Search:

Type: Posts; User: Targus

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. strange IAT2 map on Verano 2.4L , help pls.

    Hello

    Read my car and see IAT2 map is strange , here is stock attached. Could some one give me idea. Or IAT2 map useless !
    -could you check stock or tune map and give me advice ?
    -could advice...
  2. Replies
    1
    Views
    1,023

    could you send your tune ? where are you located ?

    could you send your tune ? where are you located ?
  3. Replies
    10
    Views
    4,373

    cruze 1.4t advice from masters

    Hello,

    I am not successful about acceleration after 3500rpm could you advice me what to do ?
    here is my tune and stock and tuned file about cruze1.4t at, could you check and inform bad and good...
  4. Replies
    1
    Views
    1,016

    I did hundreds of S76GM tunes, you can contact...

    I did hundreds of S76GM tunes, you can contact with me.
  5. Replies
    4
    Views
    3,261

    i did it before , but I did it again after you...

    i did it before ,
    but
    I did it again after you ask me , it is working after resync today .
    thx a lot ..
  6. Replies
    4
    Views
    3,261

    I tried new another two cable with my regular nb...

    I tried new another two cable with my regular nb that I used with MPVI before, also I tried newly fresh nb and three kind cable its same .
    Can not connect to the car neighter VCMsuite nor...
  7. Replies
    4
    Views
    3,261

    MPVI2 Dedect protocol failed

    I had my MPVI2 replacing with MPVI interface , two weeks before!
    the same E83 that I connect before with MPVI, I can not connect with MPVI2 now.
    It gives "dedect protocol failed". i already...
  8. Can we use MPVI2 interface as a J2534 passtrough

    I need to do diagnostics before I tune ,
    instead of replacing the interface can I use MPVI2 as a J2534 interface for GDS2 or etc ?
  9. I had similar issue but I dont remember how to...

    I had similar issue but I dont remember how to fix that .
  10. Replies
    2
    Views
    1,231

    Tunerlock E78 and E83

    Could I do Tunerlock for both pcm ?
    Does it lock both read and write or only for write ?
    How can I do it? Can you show me sample ?

    thx
  11. Replies
    1
    Views
    1,901

    Dont care the list much, your car E83 ecu could...

    Dont care the list much,
    your car E83 ecu could be identified with Hptuners , dont worry about it.
  12. Replies
    1
    Views
    6,158

    6T40 tcm VIN change

    Is it possible to change VIN for 6T40 tcm on Cruze ?

    because of defectife tcm board replacement with different ID board for same tcm .
    If ID is different can not do sps to change vin.
  13. Replies
    6
    Views
    2,228

    VIN change is not eneugh to swap controller, you...

    VIN change is not eneugh to swap controller, you need to write immo and pin code also ..
  14. Replies
    3
    Views
    1,698

    where is my account?

    I just found web site is changed to new , can not get in to my account !
    I tried to login , can not ! then I tried register with my email , ıt make new account with my email adress , why ?
  15. Replies
    14
    Views
    6,071

    I tested fan controller parameters today and...

    I tested fan controller parameters today and check the result by GDS2 , it is disappointed.
    E83 module have a mistake I think I couldnt add the picture files to show the states.
  16. Replies
    8
    Views
    6,408

    which pcm stock.bin files do you need for ?

    which pcm stock.bin files do you need for ?
  17. Replies
    14
    Views
    6,071

    which ecm ecuipped on it? E78 or E83? it is...

    which ecm ecuipped on it? E78 or E83?
    it is related with OS on ecm .
    You must check engine diagnostic with GDS2 if ecm can control electric thermostat.
    I know even equipped electical controlled...
  18. thx for reply , there are one simulate heater...

    thx for reply ,
    there are one simulate heater circuits that I found , here is the link.
    http://www.ac.com.pl/ru-produkty-autogaz/o-/stag-afr/337/
    I think should get this and try and see the result.
  19. Anyone works with PLX SM-AFR wideband on E83 - E78 ?

    I am planning to get PLX wireless AFR gauge and shows on android phone.

    I could install wideband sensor instead of upstream-sensor1 , and 0-1V output could connect to E83-E78 but needs to connect...
  20. Replies
    3
    Views
    1,675

    I need to use lock my tune for some testers , to...

    I need to use lock my tune for some testers , to avoid they bring the car to another tuner for copy my tune.
  21. Replies
    3
    Views
    1,675

    E78 and E83 lock ?

    I have some question about tune lock option,

    * if the tune is locked, is that lock the ecu reading and even GM service update by sps ?

    * is that possible to read by any other tool can read...
  22. Replies
    4
    Views
    2,806

    1.4t Cruze 2013 tune is not satisfied

    I tuned the car (with manual transmission )but result is not satisifed .
    Neither pedal response nor acceleration at low rpm(1000-2500) didnt changed a lot.
    Here is the stock and tune files , what...
  23. thx , Why ECT modifier table does not effect...

    thx ,

    Why ECT modifier table does not effect timing advance increase ? according to theese modify timing advance should be seen more 2-3 d3gree because of reduction is less than before ?
  24. thx for the Reply Mark, ok to back IAT...

    thx for the Reply Mark,

    ok to back IAT calibration , another theese are ok or good enugh ? Do I need mod any more maps ?

    No retard , didnt take alog but I follow the timing advance for high...
  25. why timing advance dont change theese 78 and e83 files and tunez

    Hello Pro's ,

    I am coming from Siemens ecu's on GM cars , and have experience and good results about them.
    And I had a HPT GM pack but not use and work a lot since 2015.

    Here is my works about...
Results 1 to 25 of 26
Page 1 of 2 1 2