Search:

Type: Posts; User: wadejesu

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Thread: help

    by wadejesu
    Replies
    2
    Views
    126

    Sensors are hosed up, are you sure a mouse didn't...

    Sensors are hosed up, are you sure a mouse didn't chew up your wiring harness, ?
  2. Replies
    5
    Views
    265

    What is your spark plug gap?

    What is your spark plug gap?
  3. Thread: Dumb Question

    by wadejesu
    Replies
    6
    Views
    329

    Got it figured out, Timing is everything,...

    Got it figured out, Timing is everything, Smoothed PT tables, removed all negative in Min spark table, Sultan changed PE and injector setup, Car has never run better. Special thanks to...
  4. Replies
    3
    Views
    539

    Make sure after each change you do a throttle...

    Make sure after each change you do a throttle relearn and reset adapts.
  5. Thread: Decel pop

    by wadejesu
    Replies
    6
    Views
    527

    While still trying to eliminate decel pop,...

    While still trying to eliminate decel pop, another curve, looking at several maps, Minimum spark table, some are RPM vs aircharge and some are RPM vs MAP KPA, what's the difference ?
  6. Replies
    8
    Views
    308

    I have access to a 2020 Ram 6.4 I'll try it later

    I have access to a 2020 Ram 6.4 I'll try it later
  7. Replies
    8
    Views
    308

    Did you try just reading the tune and saving it...

    Did you try just reading the tune and saving it in hpt?
  8. Replies
    5
    Views
    642

    Hey Bill Can you add The Ballenger V2 NTK...

    Hey Bill Can you add The Ballenger V2 NTK Industrial WB sensor to Transform list?
  9. Replies
    4
    Views
    701

    Good find, I have a spare just in case

    Good find, I have a spare just in case
  10. Replies
    2
    Views
    254

    That's exactly what I did I have mine zip tied so...

    That's exactly what I did I have mine zip tied so you don't have to keep fumbling under dash, plus with the MPVI2 up high you can view all the LED's.
    ...
  11. Replies
    24
    Views
    2,941

    Thought it only worked with MPVI2?

    Thought it only worked with MPVI2?
  12. I think it will but you have to use beta and...

    I think it will but you have to use beta and resync, Mine was intermittent but it did work, Start trigger worked fine, just didn't stop everytime.
  13. Thread: Dumb Question

    by wadejesu
    Replies
    6
    Views
    329

    Here's a stand alone log, I don't remember it...

    Here's a stand alone log, I don't remember it idling that long where the timing drops out, might have something to do with interface. Not sure.
  14. Thread: Dumb Question

    by wadejesu
    Replies
    6
    Views
    329

    Thanks, what do you think about the minimum spark...

    Thanks, what do you think about the minimum spark table, -5.0 in the low rpm range?
  15. Electronic throttle under airflow feed forward, (...

    Electronic throttle under airflow feed forward, ( everything set to 3.8),Under spark Transient tip in, (reduce all by .5%) Under Torque Management ,Driver demand, Pedal Character, Throttle WOT...
  16. Thread: Dumb Question

    by wadejesu
    Replies
    6
    Views
    329

    Dumb Question

    I'm trying to chase down a decel pop issue, high gear below 3000 rpm, I've tried some DFCO settings , not much help, car runs fine except for that. 6 spd Manual, 426 Stroker, Maggy , Kooks LT , high...
  17. Replies
    8
    Views
    567

    I was in your shoes a year ago, still learning,...

    I was in your shoes a year ago, still learning, Your in for a mind boggling experience.
  18. Replies
    11
    Views
    711

    I have a 426 PVS 2300 8lbs boost, Here is my...

    I have a 426 PVS 2300 8lbs boost, Here is my start up
  19. Replies
    6
    Views
    322

    Did you uninstall VCM suite, then reinstall it?

    Did you uninstall VCM suite, then reinstall it?
  20. Replies
    1
    Views
    162

    Open Loop/ Closed Loop

    Looking at several tunes in the repository and on this forum, I noticed variances from 10 deg all the way to 300 deg ECT to enable closed loop. Engine-Fuel-Oxygen Sensors-Closed Loop Enable - Coolant...
  21. Replies
    2
    Views
    482

    I got mine working per the guide, have both...

    I got mine working per the guide, have both triggers set to button, However to get it to stop logging, I have to hold button in till host and OB led flash, release, then push button again, then it...
  22. Replies
    1
    Views
    298

    Stable vs Beta

    What are the main differences and when should you use which?
  23. Replies
    11
    Views
    711

    Cold start like crap what? Backfire, surge,...

    Cold start like crap what? Backfire, surge, stalls, ??? what does it do exactly ?
  24. Thread: Decel pop

    by wadejesu
    Replies
    6
    Views
    527

    Most of the tunes I looked at have that under 5

    Most of the tunes I looked at have that under 5
  25. Thread: Decel pop

    by wadejesu
    Replies
    6
    Views
    527

    What it this delay? is it in ms, seconds or what,...

    What it this delay? is it in ms, seconds or what, also I noticed on many SC tunes spark control is enabled, ???
Results 1 to 25 of 40
Page 1 of 2 1 2