"Partial TCC Apply" in my experience is the absolute minimum turbine RPM for any TCC application for each gear, just like you are suspecting. There are also "Closed Throttle TCC Apply", which are the...
Type: Posts; User: Tiron
"Partial TCC Apply" in my experience is the absolute minimum turbine RPM for any TCC application for each gear, just like you are suspecting. There are also "Closed Throttle TCC Apply", which are the...
This is what I ended up with for my car (actually the wife's car). Some settings were based on a stock SRT8 NAG1 file, pressures upped to SRT8 settings, and the shift torque reduction was turned up...
I have a stock file from a 2014 5.7L Charger Pursuit if you are interested.
118234
I've just started poking around the Dodge stuff for trans (2011 545RFE), but I'd try playing with the settings in Trans > Shift Pressures > Upshift > Duty Cycle Initial Value for the 1-2 table. I...
Pretty sure I got this on a 2012 F150 EcoBoost when I tried to read with the engine running. Try reading it key on engine off and see if it works any better.
First thing I would do is increase the Base Running Airflow in Engine > Idle > Airflow > Base Running Airflow / Idle Airflow. This should open the IAC more all of the time that its not in adaptive...
Not sure you need a special tune to feel the shift points, if your shifter is still connected in a stock-like manner (P R N D 3 2 1).
Just put the shifter in 1, and slowly move it up as you drive....
You can control both fans using a 99 PCM -- I just did this to my 99 6.0L LQ4 truck, here are the settings you need:
Settings for 1st fan:
System > Fans > Hardware > Fan Type = 2 Fans
System >...
Trans > Torque Management > Torque Reduction (Normal for normal, Performance for tow/haul mode)
That is the table that determines how much power to pull during a shift. This table is percentage of...
I have a 2006 Mustang
2006 c6?
79930
I have a 99 2500 with 6.0/4L80, does that work? I'd have to go read the file out for you.
Thanks!
Anyone have a stock file from an LS7 Corvette?
VCM Editor now fails writing my 2012 5.0 Mustang. It did write successfully the first time, but when I came back to write again it said:
"Uploading boot loader"
"Erasing"
"Write complete".
It...
Here is my file from a 2006 GT manual, OS ID FBNF1G3.
I have seen problems on my car as well, 2006 Mustang.
It seems like it's going to work, gets about 70% finished writing, and then fails.
After that I get ignition cycle problems for at least...