may have to try letting it shift into third before i make a pass
Type: Posts; User: kirk tarrant
may have to try letting it shift into third before i make a pass
My rpm level X never shifts into 3rd first pass off the trailer even after a decent warm-up.
Is there any low temp protection that's not visible in hp tuners?
the second pass is fine.
I have ls3 map in my c5 with a adapter harness.
Used the ls3 data
Its reads around 65 at idle(235/250 cam) but when i apply throttle its drops down to 25 kpa.
Is this sensor compatible with the...
Will try as well. I'm using a sneakeater 102
i did not think the x link would work as it has 8 pin plug and the c5 has a 6 and 2.
Following. i got snake eater 102 on mine. i repinned my racetronics harshness and it works fine with car off but i sometimes get 1516 when running
What are you using for etc scalar?"
Any one make any progress with getting these to work on the 411 ecu?
it appears the shift points are all off schedule. I have not been out in the vehicle yet.
The p 101/102/103 Max pressure tabs are disabled.
What else can cause SD to cause problems with a 4l60(411 ecu) shifting?
99109
Having trouble finding good data (411)
Anyone willing to share?
Trying to help a friend if mine with his 2008 procharged vett (fast 85cc injectors)
This car was tuned couple of years ago and it does not idle well.
Car was lean at wot and we scaled the maf and...
If i do the half ifr/double stoich set up to scale some 85lb injectors will STFT still work ?
Looks like currently the car was set up at 63.5 and the maf just scaled to make up for the rest but...
2008 corvette with a procharger kit.
Car shifted fine and went for a retune and shortey after the trans did the p2724 and P0700
owner replaced trans and same problem still exists.
A trans tune...
i just pulled some 02/rich/lean vs air flow from another tune and im gona try it.
any one have any input on tuning the o2 sensors?
its fine at cruise. it has texas speed long tubes . they have the longest primars on c5 headers.
bad bank 1 o2 sensor?
700107001070010
Tune attached. i will get a data log.
02 z06 with btr stage 4 cam.
Tune was from a car with same set up. I have been adding some timing to work on drive ability . Other then the usual bucking...
Command afr is asking for a rich start.
my driver side 02 sensor is reading around 100mv lower then the passenger,The wide band is on driver side as well
Any one have this trouble with a big cam?
seems adding after start enrichment will not help?
Any one else have input?
set up a math parameter for wide band error with my egr wide band.
I don't think its working right as it seems to almost mirror the Afr readings?69246
Thanks so much. now to figure out the wideband error pid!
Did a ntk wideband via egr input.
It shows up fine and 20 afr shows at 20 afr but it will not show a decimal point.
Any help?68685
any one have some data i can use and known to work well to get my throttle response better?
good hopefully the rumors about the latest software are wrong then.
I'm not sure why they would block that anyways! maybe to force people to buy the pro version.