Search:

Type: Posts; User: Billycar11

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    792

    I believe hptunners will tell you if you should...

    I believe hptunners will tell you if you should do a table write or a full write just do what it suggests
  2. Replies
    7
    Views
    792

    Probably just put your original bcm and pcm into...

    Probably just put your original bcm and pcm into the new car no credits needed that way or find a buddy with a tech 2 to match the bcm to your pcm and if.none of that works yea another 2 credits and...
  3. Replies
    7
    Views
    1,363

    sure its mostly overkills tune i bought a pcm...

    sure its mostly overkills tune i bought a pcm from him but it gave a check engine light for an o2 sensor p0053 that it didn't with the stock pcm so i just copied the tune off and licensed my pcm ...
  4. Replies
    7
    Views
    1,363

    Well all progress has stopped they replied with...

    Well all progress has stopped they replied with this.

    "I do not have any suggestions as we are not tuners and aren't able to assist with tuning. We don't know if those parameters would help, they...
  5. Replies
    7
    Views
    1,363

    they respond back by adding 3 new things in the...

    they respond back by adding 3 new things in the newest beta
    2052 - RPM limit AFR Thresh
    2053 - RPM Limit AFR Time
    12074 - RPM Limit AFR

    they are under engine>fuel>cutoff DFCO
    i dont...
  6. Replies
    7
    Views
    1,363

    seems like a common issue on 06+...

    seems like a common issue on 06+ https://forum.hptuners.com/showthread.php?71553-did-i-miss-a-speed-limiter-still-top-out-at-110&highlight=speed+limiter
    my 07 does it too tested it out going to...
  7. Replies
    2
    Views
    722

    its not on the supported vehicles list. ...

    its not on the supported vehicles list. https://www.hptuners.com/vehicles/
    but they did just add toyota support with the new mpvi2 they may or may not have future plans for it
  8. but people forget that they are locked out of...

    but people forget that they are locked out of there own car, yes you can reflash it if they remember but what if it is so heavily modified that it is not even safe to run on a stock tune then they...
  9. nah what happens when some client moves away or...

    nah what happens when some client moves away or you no longer offer services. if your tunes are good they wont need to go elsewhere for someone to read the tune and will come back to you if they need...
  10. would think it has to do with the idle speed vs...

    would think it has to do with the idle speed vs ect try messing with that move the cold cells over to the more warm side but leave operating temperature alone ~180-~220 F
    80287
    probably also has to...
  11. Replies
    7
    Views
    1,188

    yeah had that happen to me too i was like what...

    yeah had that happen to me too i was like what the urf you HPTuners guys could have sent an email saying you need to make a new account so we were not all annoyed by trying to get in.
  12. Replies
    6
    Views
    820

    hmm maybe try re enabling the dtcs that thread is...

    hmm maybe try re enabling the dtcs that thread is old from 2007 maybe they made it so all you have to do is set vats to off an hp tuners staff guy said somewhere most cars just need to set vats to...
  13. Replies
    6
    Views
    820

    maybe try checking the ses box like this guy says...

    maybe try checking the ses box like this guy says https://forum.hptuners.com/showthread.php?12399-Disabling-VATS-on-non-Alloytec-V6-car-PCMs&p=518933&viewfull=1#post518933 and see if that works
  14. Replies
    4
    Views
    1,750

    weird your trans temp is above 70c, i have seen...

    weird your trans temp is above 70c, i have seen others say even when its up to temp it wont work if you tried it before it was hot enough try again when it hits like 80c but dont attempt to learn...
  15. Replies
    1
    Views
    422

    no connecting and reading with scanner will not...

    no connecting and reading with scanner will not reset readiness monitors but clearing codes or writing an new tune will reset them
  16. Replies
    3
    Views
    537

    if you put a new pcm in you will need to...

    if you put a new pcm in you will need to relicense it and rewriting the old one can be risky and could have to relicense it if you do not put the same os back on
  17. Replies
    2
    Views
    821

    i think support needs to transfer over your...

    i think support needs to transfer over your serial number and credits or you can get your friends account from him and change over the email to yours
  18. Replies
    6
    Views
    666

    if the tunes not locked you can read it with vcm...

    if the tunes not locked you can read it with vcm editor you log with scanner. then you need to license it to edit even if that shop uses hp tuners because it is only licensed to there unit.
  19. Replies
    3
    Views
    582

    this is the smallest thing i could think of that...

    this is the smallest thing i could think of that runs full windows that has a screen attached https://www.youtube.com/watch?v=Ghe0LSDrVmA
  20. Replies
    3
    Views
    582

    windows phone is unable to run hptuners its not...

    windows phone is unable to run hptuners its not x86 its arm so you would be unable to flash ,you could log with a non windows phone with a app like torque but you cant import that to vcm scanner
  21. Replies
    3
    Views
    548

    you should still pass with unsupported showing...

    you should still pass with unsupported showing they only fail you if it is incomplete for the front o2 codes idk how to fix that
  22. Replies
    49
    Views
    20,862

    try under another user account see if that...

    try under another user account see if that account is just broken
  23. Replies
    1
    Views
    395

    wrong website use this one...

    wrong website use this one https://www.hptuners.com/
Results 1 to 23 of 24