Search:

9 months later this still doesnt work. Has anyone come across a solution?

OK, I was about to order the 30-0334 but this post gives me pause. On a swap vehicle (93 rx7 with 2013 LS7), i only have the ECM, no other modules. Will the 30-0334 work? Obviously I don't have the...

Another update- tried a snap on scanner today and gave the same message- cannot perform with faults present

so to follow up.... after a ton of searching and reading, i am more confused than ever on the e-brake aspect of it. In fact- i found 2 directly conflicting posts in 2 different threads about it......

I keep reading people discussing parking brake, but the wiring diagram for the corvette doesnt show there is a parking brake input to the ecm. Is there really a parking brake input?

My ls7 is 100% stock. I tried turning DFCO off and CFCO off and it made no difference. Im trying to get everything functioning as it should in the vette

So interestingly, i did get both those messages from HPtuners during my numerous attempts over several hours. So i dont think the ect or the brake input are my issue. Im trying to see if i can find...

I dont know. I tried it and I still get the error that there cannot be any faults even though i have no active DTCs. Im guessing im not meeting some parameters GM wants but it obviously wont tell me...

I actually tried looking at a camaro tune. I tried a couple different combinations but it seemed like the final drive ratio never changed the speed reading, that's what made me try leaving it at 1...

Just to update for anyone searching, i put 66 in the vss pulses per rev and 1.00 in the final drive and it appears to be pretty accurate. I got it by taking the 17 pulses per trans output multiplied...

I have a ls7 swapped into an FD rx7 using a modified vette harness and an 06 z06 E38 ECM. I am getting a P0315 code for the crank relearn. I have tried a million times to get the relearn to work...

just thinking this through- is it possible since the signal is coming from the BCM in the original car that the ECM is looking for 12V and not the 13-14V that would be coming from a brake signal in a...

Did anyone ever come up with a solution for this? I have a 2013 corvette E38 in a rx7 swap. Same issue reported here- when the key is on, engine off, scanner shows brake signal works perfectly. Start...

Hi all-

I have an LS7 swapped into an FD rx7 using a t56 from an 04 GTO. My ecm is from a 2013 Corvette Z06. I am currently struggling with the vss settings to get accurate speed reading in the...

Hi all-

I bought a used ECM from a 2013 corvette Z06 off ebay to use in my ls7 swapped FD RX7. All i wanted to do initially was disable VATS so that i can get the car running with the stock tune....