chances are, your tuner just has the codes disabled but you're still running in a "reduced engine power" in the background
Type: Posts; User: Jace Jackson
chances are, your tuner just has the codes disabled but you're still running in a "reduced engine power" in the background
Is the truck deleted
Contact support and they will add it. They added all of those for me on the 3.0L Powerstroke
Parameter 14590 - Base Operating Mode will tell you which of the Map # is in use.
Parameter 14589 - Injection Config for EOM will tell you which Config # is in use.
Parameter 14588 - Engine...
135780
General>Shift Type Config Set all of those to 0 just like my picture. This will disable 1st gear completely.
Looking for some advice on disabling first gear. I've tried hundreds of times following the 4wd low table for disabling first gear with no luck at all. With first gear upshift OSS set to "zero" the...
can you post a log? i can help you out.
LTFT's need to be within + or - 3%. i always try to get them within -1%
102257
Load this file up and get some more logs for me please. If easier you can email @ [email protected]
Go through the tune, and compare to your stock tune. This will show you what has changed and what is different. It will give you a starting point to learn what needs changed.
You need to download vcm beta And use that
Get me some more logs and i can help you out. Need idle logs for a few minutes, cruising around and wot. Get me as much data as you can
102241
I have adjusted your VE Table and Maf based on your log. Your Long terms and short terms are all over the place adding up to 25% fuel. I smoothed out the VE table and increased it...
note: Vcm beta is required to open this file
102239
I have attached the E85 tune for you
102237102238
I have attached the tune and graph setup for you
Nothing it was bone stock. But the stock VE table on those trucks is horrible. This is set for 91 octane, truck drives amazing and shifts perfectly. I have updated the tune and will post tomorrow.
Can you post your file please?
Download the latest vcm beta, shutter override should be on the latest beta
I'm willing to share my 2.7 e85 file with you if you are looking for a big power increase. you MUST use full e85 for this tune. Reply back and let me know
all 2.7 engines use vacuum reference instead of positive pressure for wastegate control
Download the latest Beta from hp tuners. Then retry.
Your VE and MAF table needs adjusted. On your Log, the computer is trying to add 10% fuel in the upper rpm range.
102080
If your Truck is otherwise stock try this file. This is a file i worked on for a while on a 2000 5.3 silverado. All LTFT's are within -1%. Truck drives great and pulls very good.
Does the truck run fine? Does it start and idle fine? What do your LTFT's look like? VE table appears to be a little rough, also your High Octane spark table appears to be stock. Try increasing the...