Search:

Type: Posts; User: MarkTucker

Page 1 of 20 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    1,023

    NBMY2KTA, Firing order and IAC reset position...

    NBMY2KTA,
    Firing order and IAC reset position are stock values for this vehicle. ETC Area Scalar is for ETC fitted vehicle only, didn't believe that it needed to be adjusted for cable drive throttle...
  2. Replies
    6
    Views
    1,023

    Cold Start Issues!

    So having a tough time with the cold startup on this car. 1998 Trans Am 5.7 (FAST 92 intake manifold, 92mm throttle body, Summit 8715R1 camshaft (222/234, .600/.575, 115+3), 36lb/hr injectors,...
  3. 2016 Cadillac Escalade 6.2 - BTR Stage 3 Truck Cam

    As the title states 2016 Cadillac Escalade 6.2 with a BTR Gen V Stage 3 Truck camshaft (recommended valvesprings and pushrods). It does have stock torque converter.

    I am looking for...
  4. ISO - 68170238AB Hellcat Injector - GM Data Characterized

    Has anyone used the 2015-2020 Hellcat stock 600cc (I believe 57lb/hr @ 60psi) fuel injectors in a GM application (Specific controller: GM P01)? Mopar P/N: 68170238AB

    If so, does anyone want to...
  5. Replies
    3
    Views
    767

    You recommend performing doing an "Write Entire"...

    You recommend performing doing an "Write Entire" with HP Tuner 2bar SD OS 1253005 versus trying to use this existing EFI Live custom OS?
  6. To update this. Was able to get the fueling all...

    To update this.
    Was able to get the fueling all dialed in with the upgrade LFX MAF in the 3.5" MAF straightener tube.
    I ended up taking the car off of the dyno and did a pull on the street and did...
  7. Replies
    3
    Views
    767

    What P01 OS is this? - OS 2020003

    Looking to see if anyone know what operating system this is? This ECM was bought used with this operating system, and I don't believe that I have seen this OS before.
    It has the following tables...
  8. To update on this one, we installed a LFX MAF...

    To update on this one, we installed a LFX MAF sensor into a 3.5" MAF straighten tube. The MAF no longer just plateaus around 12,000 Hz and am able to control fueling at WOT (as before, I tried...
  9. Paul, Your descriptions of each table to...

    Paul,

    Your descriptions of each table to adjust are based off of SCT's software, correct? So I don't exactly understand some of your steps above.

    I believe I understand all of it other than the...
  10. Replies
    11
    Views
    3,861

    Alvin, Good tip. I have been told not to...

    Alvin,

    Good tip.

    I have been told not to simply max the peak torque tables.
    My common practice has been to increase the areas typically above 2,000/2,500 rpm (leaving the areas around idle...
  11. Bump. Anyone have any guidance on this,...

    Bump.

    Anyone have any guidance on this, looking for the correct changes for when going from returnless to boost referenced return style fuel system on this vehicle.
  12. Replies
    11
    Views
    3,861

    Thank you both Jason and Alvin for the...

    Thank you both Jason and Alvin for the information and experience.

    I do not have any current issues with this vehicle. Only asking to understand better. As I have seen it done each way (PT lower...
  13. Replies
    11
    Views
    3,861

    Peak Torque vs Driver Demand

    Should Peak Torque always be higher than Driver Demand?

    Example: Stock 2021 Camaro SS, manual (photos below)
    121875
    121876
    121877

    From the screenshots, you can see that almost the entire...
  14. 2009 Mustang GT Return Style Fuel System Setup - Questions?

    I am looking for the correct steps to setup a return style fuel system on a 2009 Mustang GT 4.6 3V.

    The car currently has a Fore Innovate dual fuel pump assembly with return style fuel pressure...
  15. Greg, Thank you very much for the data. I...

    Greg,

    Thank you very much for the data.
    I sent you a PM with a question, related to the data.
  16. Looking for data, SEP - "Long/Deka" LS1/LS6 Style - EV1 (Jetronic) plug - 1000cc/min

    I am looking for data for the SEP - "Long/Deka" LS1/LS6 Style - EV1 (Jetronic) plug - 1000cc/min, 96lb/hr@43PSI Injectors for use in a 2000 Camaro 5.7 w/P01 ECU and factory style fuel system.

    I...
  17. 2010 Camaro 3.6 Weird Ignition Issue and Possibly Maxed MAF?

    Looking for some input on problem areas on this tune.
    This car is a 2010 Camaro 3.6 LLT with the E69 ECU. It is twin turbocharged running approximately 7psi of boost. Currently running the stock LLT...
  18. Replies
    6
    Views
    1,671

    sent you an email.

    sent you an email.
  19. Replies
    6
    Views
    1,671

    Update to this post. I have had some very nice...

    Update to this post.
    I have had some very nice help from Fuel Injector Clinic (FIC), trying to figure out the proper way to input the injector data for the FIC 775cc into the EEC-V ECU using HP...
  20. Replies
    6
    Views
    1,671

    So let me be more blunt with this one. I need...

    So let me be more blunt with this one. I need help getting the injector data imported correctly. With "2002 Mustang - FIC 775cc Injectors" file I am unable to get the vehicle to start up.
    Just to...
  21. 2015 Polaris Slingshot Tuning - Supported?

    Are the Polaris Slingshots supported via HP Tuners?
    I did not see it on the vehicle list but wanted to make sure as there has been so much new added lately.

    If someone at HP Tuners sees this...
  22. Replies
    8
    Views
    1,883

    If you would post a log up as well to help us see...

    If you would post a log up as well to help us see the area of concern.

    First and most important, the fuel injector data does not appear to have been adjusted for your larger fuel injectors.

    So...
  23. GM LLT, E69, Optimum Torque/Torque to Load

    I am looking for input on others experience with these tables?

    Do anyone adjust the Optimum Torque and/or Torque to Load tables on the LLT 3.6 engines with the E69 ECM?
    121164

    If so, what is...
  24. Replies
    6
    Views
    1,671

    2002 Mustang GT, EEC-V, FIC 775CC

    2002 Mustang GT with EEC-V, I have just installed FIC 775cc injectors. Updated the tune file using the provide injector data from FIC website. Unable to get the vehicle to run with just injector...
  25. Replies
    1
    Views
    1,097

    Can you please post your tune file and a log of...

    Can you please post your tune file and a log of the issue that you are seeing? To make it easier for someone to further assist you.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4