I need a 5.0L mustang log. I have a 2011 3.7L and I'm trying to dial in the transport delay for longtube headers. The parameter I'm looking for, total transport delay, is supported on the coyote and...
Type: Posts; User: [email protected]
I need a 5.0L mustang log. I have a 2011 3.7L and I'm trying to dial in the transport delay for longtube headers. The parameter I'm looking for, total transport delay, is supported on the coyote and...
I have a 2010 6.4L powerstroke f250 and need to put a replacement transmission controller and program/mate it to this f250. Is this possible with hp tuners software? Im assuming i need to write the...
I 2nd the transport delay tuning. Headers and high flow cats usually mean the oxygen sensor is moved further down and the delay will play a big part into fuelling. Most tuners just multiply the lower...
I think what i was feeling was the fueling being off, which was why I thought maybe calibrate airflow to clean up fuel trims. My boost gauge shows 8 psi still but I need to get the oxygen sensors...
I just finished installing bbk longtube headers and high flow catted x pipe on my procharged mustang.
What adjustments are usually made when going to longtube headers for making power? Im not...
Idle can be pretty high if theres a lot of overlap at low rpm. big cam cars normally are at 1000rpm. i played around with -40/20 850-1000 till it would linger in a map. i had mufflers though I gave...
Calibrating my MAF on 2011 3.7v6: JLT intake, ported manifolds, and borla atak exhaust.
Should i be editing my airflow vs voltage or airflow vs period? Ive heard people tell me period table and...
I followed this coyote video when originally setting up my histogram and for the changes to my period vs airflow table, it sounds similar to what youre describing, but I have some questions about the...
I found my issue with only filling one cell.
I had set up my graph for monitoring STFT with maf period as the row axis, HOWEVER I forgot to add MAF period into my list of parameters in my...
Hi, I'm struggling to get any usable data for calibrating my MAF. Im only filling one block.
Ive set up a graph with my row axis based off mass airflow period values. The parameter im trying to...
So I have a pony package v6 mustang. The car has a 3.31 final drive, and If I were to change this or upload a stock v6 mustang tune I would need to correct this from 2.73 to 3.31.
This makes me...
Thanks for the channel configuration and tune! After looking it over and changing channel configurations to what you sent me I went for a few test drives running the different tunes and logged new...
Hi, I'm a beginner tuner and wanted to get some advice about my 3.7 v6 mustang tune.
its a 2011 3.7 with a 2012 junkyard engine in it, but unless someone can enlighten me, the engines are for the...
Hi, I'm having a problem ever since I picked up a junkyard 2012 3.7L v6 engine and installed it in my 2011 3.7.
The new engine was an automatic, so I swapped my flywheel and clutch over to the new...