Search:

Type: Posts; User: staytuned

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Add fluid to it even though it is good. At least...

    Add fluid to it even though it is good. At least a quart. Drive and light warning will turn off
  2. Me too. I found it in the first thread for tuning...

    Me too. I found it in the first thread for tuning 7.3's HPT posted it. link: https://forum.hptuners.com/showthread.php?75236-HP-Tuners-Now-Offering-99-03-Ford-7-3L-Powerstroke-Support
  3. the repository sample is from the first thread...

    the repository sample is from the first thread for tuning 7.3's the other is from customers 1999 7.3 Dually
  4. Looking for stock 7.3 tune for 1999 auto F250/350

    I used the tune on the forum here to check against mine but not sure if it's stock. Having very early TCC shift points and firm shifts due to TCC staying on at low speed. Trans line pressure is up...
  5. Replies
    6
    Views
    475

    Just wondering why advance cam timing at upper...

    Just wondering why advance cam timing at upper end and not at the lower rpm range. I thought advancing it in the lower rpm range and retarding as it comes up and fully retarded by 5k would give the...
  6. Replies
    11
    Views
    828

    This worked for me ! unchecked high speed

    This worked for me ! unchecked high speed
  7. Never heard of a P060. I tune GM diesels in EFI...

    Never heard of a P060. I tune GM diesels in EFI Live. Some of the knowledge carries over but descriptions are different, the scan tool is not as good so maybe that's a p0606 or p0603 ?
  8. Try a different lap top if when you go to help...

    Try a different lap top if when you go to help section and click (about) it will say no update found if it is connecting to the site. If it shows an error means it is not connecting. Could not figure...
  9. Tried a stock tune ? that will eliminate 1...

    Tried a stock tune ? that will eliminate 1 possibility.
  10. Replies
    1
    Views
    230

    Yes, and EFI live does not need unlock either.

    Yes, and EFI live does not need unlock either.
  11. Replies
    5
    Views
    316

    Can't raise apply pressure but you can decrease...

    Can't raise apply pressure but you can decrease desired slip and increase the apply rate.So it will feel better. You may also want to turn off TCC in 1st thru 8th gear. What I can't get to go away is...
  12. for timing maps you can take the best looking...

    for timing maps you can take the best looking high elevation map and install it in all the low elevations, smooth it out and make them all the same. You can cut back egr 50% to save a bit of fuel and...
  13. Replies
    2
    Views
    333

    No it does not read the ECM at all. Opened a sup...

    No it does not read the ECM at all. Opened a sup ticket and they stated disconnect battery and try again. Did that same thing. SCT can write it and unmarry it. But HPT reads nothing
    for ECM. Only...
  14. Replies
    2
    Views
    333

    2005 6.0 not reading ECM tune

    Vehicle was previously tuned with SCT. They instructed me how to un marry and check that it is not married. HPT will read the FICM and Trans but not the ecm. Any Ideas ? Tried multiple times....
  15. those flashpaq tunes have to be generated from...

    those flashpaq tunes have to be generated from your original read, with a different file extension than HPT. How did you tune a ford with EFI Live ?
  16. Replies
    2
    Views
    356

    Why not use the 2009 TEHCM in the 2007 Trans ?

    Why not use the 2009 TEHCM in the 2007 Trans ?
  17. Can auto start/stop be disabled on a 2015 F150 v8 ?

    Can auto start/stop be disabled on a 2015 F150 v8 ?
  18. There's a couple '08 LMM tunes in the repository...

    There's a couple '08 LMM tunes in the repository with deletes. Follow their lead without deleting anything. Cut the EGR back to at least 50% everywhere, if it sets a code for that step it back up, if...
  19. Most likely will be the solenoids going through a...

    Most likely will be the solenoids going through a cleaning cycle.
  20. Replies
    7
    Views
    502

    She now loves the way it drives. She was ready...

    She now loves the way it drives. She was ready to trade it in and we didn't even have 1500 miles on it yet. The map I posted above makes it drive like it should have from the factory. She can...
  21. Thanks for your commitment to support new...

    Thanks for your commitment to support new vehicles.
  22. Replies
    7
    Views
    502

    Thanks for the input. The harsh downshifts went...

    Thanks for the input. The harsh downshifts went away when I put the minimum timing tables back to stock. I had set both minimum tables to 8 degrees entire map. It up shifted good but that made forced...
  23. Replies
    7
    Views
    502

    2018 Yukon 5.3 6spd update

    Earlier post was new 2018 yukon with rough idle that comes and goes, poor accelerator response and surging as it runs up to about 45mph, converter hunting or coming on and off.

    Fixed idle by...
  24. Replies
    4
    Views
    397

    Have you cranked up the TCC apply ramp, max...

    Have you cranked up the TCC apply ramp, max pressure ? also some tunes come factory with adapt pressure set up to 150kpa don't know if that would help.
  25. You need to drive it easy while it relearns and...

    You need to drive it easy while it relearns and adapts. start with light steady state throttle through all the gears, do that 2-5 times. Increase throttle and repeat through all the gears. Increase...
Results 1 to 25 of 85
Page 1 of 4 1 2 3 4