Search:

Type: Posts; User: Boosted_javi

Search: Search took 0.00 seconds.

  1. I got it guy's thanks y was missing the part on...

    I got it guy's thanks y was missing the part on the channels list now it reads above 105kp thanks for the help
  2. I also did that i put it as a 2 bar because y...

    I also did that i put it as a 2 bar because y have a 2.5 bar map, but on th very right side on the option says under parenthesis (pressure) if I use it under sensor it goes back to 1 bar won't read...
  3. Gen 3 SD my scanner won't read above 105kpa

    I have a 6.0 ly6 running a edelbrock e-force 2.3L on speed density, the biggest problem I have right now is that my vcm scanner wont read above 105kpa and i dont want to be lean at wide open throttle...
  4. 103155 There is my scan with the key on is...

    103155


    There is my scan with the key on is at 95kpa today in south Texas we're at 82 degrees and I startd the truck at 5:58PM, it seem to sart just fine on the first crank. on Thursday the...
  5. Im running the fuel injector connection ls3...

    Im running the fuel injector connection ls3 1000cc. and my MAP sensor is the bosch 0261230042 2.5 bar. as to what I found in the internet for this sensor, supposedly the MAP characteristics were;...
  6. 103115 I was struggling uploading my file to...

    103115


    I was struggling uploading my file to the page, since Im new to forums. Tell me if you cant open it so I can try again.

    There is the tune im running right now sometimes it surges, but...
  7. SD TUNE on 6.0 edelbrock supercharger 2.3L stage 3 btr cam

    can someone help me check my file on my 6.0 ly6 SD tune I've been struggling tu make it run its getting better already but, when the truck is cold from not being used it cranks but won't start until...
Results 1 to 7 of 8