Search:

Type: Posts; User: JuiceNA

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Thread: Custom PID

    by JuiceNA
    Replies
    6
    Views
    663

    Get something that can read Mode 6 data from the...

    Get something that can read Mode 6 data from the PCM. I use Forscan.
  2. Replies
    4
    Views
    1,033

    I fought with this intake for a long time with...

    I fought with this intake for a long time with idle and driveability issues on my a stock 2013 engine and pcm swapped 2007. I got to the point of ditching the JLT2 and put on a stock air intake. Got...
  3. Replies
    0
    Views
    415

    Richer AFR w/cruise

    What would cause AFR to be richer with cruise control? Highway cruising, flat road, just holding speed. Without cruise, AFR is stoic. But on cruise control, it is noticably richer. (14.7 vs 13.9 per...
  4. Replies
    7
    Views
    1,007

    Also works from an SCT X4.

    Also works from an SCT X4.
  5. Replies
    4
    Views
    895

    Disclaimer - I am not familiar with the trucks or...

    Disclaimer - I am not familiar with the trucks or Gen2 coyotes.

    Based on my first hand experience with a Gen 1 coyote:
    * LTFT will be zero for a few drive cycles after a reflash. Mine don't start...
  6. Replies
    15
    Views
    1,752

    You are describing a cold start behavior where...

    You are describing a cold start behavior where there should not be any.
    Louder and gutless because timing is negative to warm up cats. Blipping throttle exits cold start on my 2013.
  7. Replies
    7
    Views
    1,766

    I have bricked mine twice with a bad flash. I...

    I have bricked mine twice with a bad flash.

    I had to force IDS (would not recognize PCM) to reflash to stock. The other time, my X4 recognized the pcm and was able to restore to stock, than load...
  8. Replies
    3
    Views
    668

    Reading PCM live data, do you have a near...

    Reading PCM live data, do you have a near accurate speed reading as seen by the PCM? Is the speedo cable driven? (you did not say what year truck)
  9. Replies
    3
    Views
    668

    I recommend you hook up the speed sensor on your...

    I recommend you hook up the speed sensor on your trans vs disabling it in the tune.

    When I first got mine running, (07 mustang, Magnum XL swap) my speedo was not functioning correctly and it was...
  10. Replies
    16
    Views
    6,523

    I swap between two strategies on my 07 with 13...

    I swap between two strategies on my 07 with 13 coyote swap.

    Cruise control - I believe the 11-12s use the same CC switch resistance values as 05-09. And the 13-14s use different resistances. Based...
  11. Replies
    8
    Views
    1,165

    Forscan can log

    Forscan can log
  12. I don't believe that switch is the reason. I...

    I don't believe that switch is the reason.

    I have experienced those 3 monitors not completing, no faults set no matter how long I drive the car.
    I have seen this on all 3 of my OBD2 Fords. The...
  13. If you have a monitor that is N/A and should be...

    If you have a monitor that is N/A and should be available (cat) something is still not back to stock. On my 13, there are 2 settings under OBD2 that affect how many monitors are available. I have no...
  14. Replies
    6
    Views
    1,931

    VSS and ratio changes is why your cruise stopped...

    VSS and ratio changes is why your cruise stopped working. Not sure why you would change those.
  15. Replies
    23
    Views
    22,520

    I am running the Crate_6 strategy in my swap...

    I am running the Crate_6 strategy in my swap w/2013 factory PCM, yes, it will get by PATS.
    It does NOT have emission stuff enabled by default, but I have enabled them. 02 monitors and cat monitor...
  16. Replies
    0
    Views
    423

    2013 GT manual trans

    Anyone know what the "Electric power steering equipped" setting does?

    Just curious. Switched to OEM strategy from the conrtol pack strategy. I 'think' the steering feels a little different....
  17. Replies
    1
    Views
    778

    You mean this guy? Eric@HPTuners

    You mean this guy? Eric@HPTuners
  18. Replies
    10
    Views
    4,431

    Gen 1 PCM, Gen 1 Coyote, and I did not touch the...

    Gen 1 PCM, Gen 1 Coyote, and I did not touch the interior except adding 3 circuits. (one throttle, one AC, and one for backup lamps)
    I will take the "old tech" of Gen 1 over taking apart my interior...
  19. A shot in the dark here. Is your speedometer...

    A shot in the dark here. Is your speedometer working and accurate?

    I was experiencing negative total timing rolling into the throttle in 6th from 2000 rpms. To get my speedo to read actual speed,...
  20. Replies
    4
    Views
    1,272

    08 Club wagon. Bone stock 5.4 2v. I am a serial...

    08 Club wagon. Bone stock 5.4 2v. I am a serial modder and cannot leave it stock lol. Vacation and Tow vehicle.

    Had an unmarried Diablo InTune. I flashed the canned performance tune in there,...
  21. Flash it back to stock with IDS, or restore to...

    Flash it back to stock with IDS, or restore to stock with tuning device used. And correct speedo with HPtuners. Or see if there is a stock read in the repository.

    While not the same year pcm, I...
  22. Replies
    7
    Views
    1,339

    Eh, I flashed mine over 300 times to get it where...

    Eh, I flashed mine over 300 times to get it where I'm happy with it. All futzing with idle and drivability. Yea, I'm picky.
  23. Replies
    2
    Views
    880

    Not sure what you are asking help with. Is the...

    Not sure what you are asking help with. Is the car running bad? Did you change to a larger MAF housing?
  24. Replies
    20
    Views
    4,764

    Min_man_vacuum_to exit mode.... something like...

    Min_man_vacuum_to exit mode.... something like that. It's been a while since I turned this off.
    Default is 4.5 in hg. Set to 25 in hg. Done. No need to mess with any of the tables.
    Parm may not be...
  25. Replies
    20
    Views
    4,764

    I disabled cat warmup with a single change on my...

    I disabled cat warmup with a single change on my 13.
    MiN_MAN_Vacuum_ setting.(sorry, going from memory here) Default is 4.5. I set it to 25, done. Classic normal startup.
    HP tuner may not have...
Results 1 to 25 of 119
Page 1 of 5 1 2 3 4