Search:

I attached the log and the tune

I have a 2011 camaro l99 dod delete and cam swap. had it remotely tuned mostly its runing ok other than lower rpm part throttle it surges slightly and i have no idea where to start. trying to avoid...

nice detailed answer. I've set the vvt tables to zero just to start it and get some base fueling done. So far ive seen very little to be gained with the vvt on this set up and even some pretty...

I have a 2011 camaro with the l99. Just did a dod delete decided to keep the vvt then realized I have no idea how to tune it. Anyone have some recommendations for the vvt tables just to get it to run...

From everything I can tell car was bone stock when he bought it. He's done just basic bolt on to it. He has no clue when it comes to the electronic stuff lol.

I tried to log on his car with the original mpvi and it wouldn't work only got about 4 pids to load and the readings were all way off.

I'm in a foreign land here so don't hang me lol. My dad has a 01 mustang with the 4.6. I've heard the mpvi2 has support for these vehicles but can be buggy. Anyone have experience with these that...

I will give that a shot easy enough to try lol

No codes

No cats cot is turned off and all rear o2 sensor stuff is disabled. I'm starting to think the o2s either need replaced or the long tube headers are causing the o2s to not stay hot enough. I'm...

02 Silverado 411 pcm with the 5.3. Yes commanded does change to a leaner value when it does this. Can't upload a log at the moment I'm on my phone. I'm not sure why it's comanding a leaner value....

I have an lm7 I've been tuning. I have the maf and ve tables done but when I re-enable the o2 sensors it will go into open loop at idle and run a little lean. I bumped up the idle a little bit and it...