my stock tune was .0208 so I divided 102 from 78 and got 1.30, then I multiplied that to .0208 and got the .0272, however I just tried your number of .0149 and the truck ran fine, throttle dropped...
Type: Posts; User: Juicebox
my stock tune was .0208 so I divided 102 from 78 and got 1.30, then I multiplied that to .0208 and got the .0272, however I just tried your number of .0149 and the truck ran fine, throttle dropped...
only when I come to a complete stop will the RPM'S fall and the throttle drops below 16.9% a day ago the RPMS fell and the throttle dropped mid drive, I have no vacuum leaks, and the fuel pressure is...
speed density setup, MAF is failed to 0 HZ and both of the codes are on MIL on first error. this does not happen all the time but I am tuning the VE table, copy, paste special multiply by half,...
I appreciate any help, what is your opinion on this calculated air mass issue I?m having now, do I just keep increasing the values until I no longer set the code?
I found the section where I can change calculated airmass for the TPS next to the MAF fail frequency, I x2 the whole graph and the vehicle ran for a bit longer and better until I again caused the...
It?s a gm map sensor part number 12592525
I don?t know what happened in a 24 hour period where I could get the vehicle to almost drive and now I have that code P1514 and it says reduced engine power...
I set the MAF to 0hz and put the 3 dtc's to MIL on first error. I added the 3 bar channel as well. I changed the MAP linear and offset settings to something I found online but I changed it back...
speed density setup
325ci to 408
102mm throttle body
holley hi ram
222/231 .602/.598 112+4
LS3 heads
80lbs injectors
76mm turbo
102312102313102314
I hooked up the AEM wideband 30-0300 x-series. I bought this one off Amazon trying to save a couple bucks. For me to do WOT tuning for my MAF and have the wideband and HP tuners to work I need that...
ok thanks for the reply
I just installed a texas speed cam 216/220 .600 lift 112 lsa and a 2600 stall converter. I wanted to be able to hear and feel the cam more by adjusting the overspeed, underspeed tables. When I...