Yes, II have Imported All this values from the manual tune. But still the same problem
Type: Posts; User: Sprudel
Yes, II have Imported All this values from the manual tune. But still the same problem
As I said, if I disable the automatic setting, the car doesn't run. It will start, I can drive in the first gear, but as son as I step on the clutch to stop again, the engine dies. It Drops below...
Hello Guys, I'v got my Mustang (2006 gt with Roush m90 s/c) auto to manual swap working.
I have only one little more problem:
If I step of the accelerator pedal and on the clutch to shift into...
Is this a tune you used for a swap?
Hello, I'm going to finish the mecanical part of my 2006 Mustang GT auto to manual transmission swap.
Now I need help to configure the ECU. In the transmission settings in vcm, there is a switch...
Hello guys, I'm looking for a tune for the "VMP Power Pack for M90 Roushcharger 05-09 GT" offten also called "VMP 500HP package for 05-09 Roushcharged Mustangs M90" can someone help?
Thanks
...
I have made the table rich at bottom to prevent the cat overheating. Before the lambda on top was 0.82 and this was even worse (the cat got hot in a few seconds).
This also occurs when I...
Do you know that values in the hp tune have influence on this calculated Temperatur?
Hey guys, actually I was trying to get a CAI running on my 2006 GT Roush M90 (5 psi) but I went into a lot of problems, now with my original Air box on I discovered that my car is running way to hot....
Thanks for reply, but the intake diameter stay the same. Only the Filter is chaged, the original intake tube were the MAF is stayes the same.
No ideas???
I now have tested the original 2007 Roush tune (modified with my auto transmission settings + activated cat protection and activated knocking sensors) with my original air box (not the cai).
...
So as I thought there are a lot of things messed up with the tune that came with my car. I have attached a Roush original tune for a 2007 M90 (manual gearbox), do you think that it would be the...
I can't get the car tuned correct. Here is what I have done to my original file to do the maf calibration via o2 wideband:
Fuel--open loop/Base--OL Fule TPS Thresh-------------> all to zero...
Ok, thanks, I will try it with the STFT and disabled ltft. What do you mean with "or kick it into open loop all the time"? Disable close loop by disabling the o2 sensors, or setting the closed loop...
Hey guys, I have installed a Ford Racing CAI out of a 2008 bullitt on my 2006 Roush M90 Automatic. The car has a AEM wideband in the left Header, it goes in VCM via serial. Now I have tried to get...
So, if the STFT is let's say +5% @ MAF 200 g/s.
I would correct it like this:
STFT +5% means the MAF measurement ist too low, so 200 g/s +5% = 220 g/s would be the correct value.
Is this...
Hello guys, I would like to know if someone can give me a MAF transfer function for a stock Roush Mustang (2006 automatic with a M90 supercharger) to adapt the Ford Racing CAI from a 2008 Bullitt?
I...
Thanks!
I'm just getting into tune my 2006 Mustang GT, but I'm confused because there is no WOT fuel table. Were do I set the lambda at WOT? Does it use the Base Fuel also at WOT?
Greetings from Germany...