To my knowledge this table is only for start up, PCM learns values as needed
Type: Posts; User: Mfdcar51
To my knowledge this table is only for start up, PCM learns values as needed
Various drive by wire tables need to be updated with the correct values for the twin 65 TB.
Do you have the stock TB? Make sure the TB value file is correct.This will have an impact on boost gauge accuracy
Less boost means your engine is moving more air. Thats good! Timing does not effect boost.Boost is a measurement of restriction
Fuel pump voltage table learning?
I believe the ecm uses base voltage table for reference , after first start it relearns as needed
Use the 2007 GT500 voltage table.Also set fuel pump Gain proportional,integal,derivative to the GT500 settings. That should get you very close
You might have bank 1 on bank 2
Reverse the wiring
every car I have seen with the 02's switched one reads very rich and the other very lean
Why do most people convert to return systems in higher horsepower applications? Are the FPDM's amperage limited? If so what is the limit? Greg Banish says the fuel pump voltage table is only used for...
Change the rear axle ratio
It seems to me that function acts as an "accelerator pump" The lower the number is more is added at tip in
I would be interested in the data