Search:

Type: Posts; User: MichaelGardinier

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    174

    Big cubes, big cam whipple help

    Cant get this girl to maintain an idle to save my life. Idle is set at 975, but she hunts roughly 200 rpms. will post a log tomorrow, but below is a rundown of what I have adjusted, then put back to...
  2. Large throttle commands, need to rescale axis for...

    Large throttle commands, need to rescale axis for more air then mess with throttle volts via logging until your happy with outcome.
  3. Off

    Off
  4. Knock sensors may need an adjustment or there is...

    Knock sensors may need an adjustment or there is an event you need to repair. Either not enough fuel or too much timing. I have my PE fueling start when the pedal is at 1.7vs as that's about where I...
  5. Bank 1 & bank 2 lean after airflow & feet forward changes on whipple build

    I have been dialing in drivability on my 426, 2.9 whipple build. One of the main things I have been dialing in is the transition into boost and also staying out of boost when it's not desired. To do...
  6. Yes, Troy's VB and TCM tuning.

    Yes, Troy's VB and TCM tuning.
  7. Engine Torque management for early model LX

    Just wanted to pass along some trial and error testing I did with my 2006 Chrysler 300 SRT-8.

    Car has a 6.1 based 426, 2.9 and making enough power to run 10.4s in the 1/4 on pump gas.....
    ...
  8. Replies
    2
    Views
    291

    Rough start up idle

    06 Chrysler 300 srt, 426, 2.9 whipple, fairly small cam for build.

    On startup the car chatters really bad and the engines shakes + belt slap until the idle actually settles in where commanded...
Results 1 to 8 of 8