Just installed a BTR centri blower cam and for the life of me, I cant get it to idle under 1000 without reving up and down or stalling. I have tried using the idle method in this forum but it didn't...
Type: Posts; User: russ472
Just installed a BTR centri blower cam and for the life of me, I cant get it to idle under 1000 without reving up and down or stalling. I have tried using the idle method in this forum but it didn't...
I just installed a BTR centri cam in my ECS supercharged 08 vette. running open loop sd tune for years. I cant get it to idle under 1100 rpm even when commanding lower. I was tryng to start at 900...
In the beginning for me, I felt greg banish's material to be a bit over my head at first. I also tried The Tuning School online courses which I would say will get you started in the right direction....
nope. they responded back to me saying they have it set up properly. I sent them a scan showing them it didn't work and they just quit responding to me.
I got fed up asking with no response, so I...
would any of you guys run a scan and see if FiCM main voltage is reading correctly. Support tells me it is setup properly, but mine reads 13-14 volts.
Obviously since the voltage needs to be above...
i ended up opening a ticket. They said they would get with engineering to see if they could do it. never heard anything back.
would it help if i open a ticket on this?
it works but it was just lagged too much when scanning
Is there anyway we can have FICM output voltage added to the channels list?
There are several standalone scanners that plug into the OBDII ports and monitor this.
i have tried running it on VM, but it seems to lag.
is your traction control turned off? if you are spinning, it could be pulling timing
Glad I could help. happy tuning!
you are logging WAY too many parameters at once. Get rid of any you don't need to monitor. i would probably keep it at no more than 10-12. Look in your channels tab also.i am sure that is overloaded...
can you post your layout file?
i have had mine stall and fail during programming. it won't brick your computer.
so when you are logging...does it initially start and then freeze, or does it never show the log during recording?
you can email it to me or if you go to the advanced reply and scroll down, you can attach your scan on your thread.
more ram would be helpful. you could probably upgrade to at least 8 gig for $50. try deleting channels you aren't using. does it show the information during playback?
If so, you may try to zoom...
how much ram are you using? i was using parallels a while back with Windows 7 and didn't have a problem (16g ram 2011 mbp). After i upgraded to Sierra, my Parallels didn't work unless I paid for...
switch fan type to pwm electric and 1 fan.
relay controls > state vs desired change all to 0
relay controls > output control vs state change all to 1
desired percent needs to be ramped...
fuel > transient > general > manifold volume
try increasing your manifold volume by 15% at a time. should help
ecm >engine > spark / ignition > advance > flex fuel advance
i have dvd 1
How much delay is acceptable for the fuel to react to the switch to PE? I have attached the log of a quick 3rd to 4th gear blast which shows the delay on tip in. If its too long, how do I fix it?
...
I am having issues with idle surge now that I have e70 (2nd fill up) vs e50 (1st top off). I increased Idle airflow final minimum and it caused idle to hang. Then decreased the idle over and under...