The PCM will not pop that fuse as it only supplies a ground to each component on that circuit. must have a wiring issue or failing component. Are you using MAF? you have it set to fail at 1 HZ but...
Type: Posts; User: PAQ
The PCM will not pop that fuse as it only supplies a ground to each component on that circuit. must have a wiring issue or failing component. Are you using MAF? you have it set to fail at 1 HZ but...
To disable the CEL go to diagnostic tab and make changes there
Did the battery go dead while flashing?
Flashing CEL is misfire
A headlight bulb is the fastest easiest way to load test a circuit
Hahaha ok... so use the 0 column across the table then? I didn't even think about the vac variable when copy and pasting the data in... I received 2 different sets of data for these injectors. 1...
I get a surge while coasting to a stop until i hit 0 mph. Should i Use the cracker table to add air or am i missing something. Im still working on the VE and have some fat areas low kpa but idle area...
With all this talk about dcr.. thoughts on that same combo plus FI? The turbo was an after thought on this engine.. its not in a heavy towing setup though
You could just add the wires to your harness... 5 I think for the iac and 3 for the tps
Not to high jack this thread...but say someone did have a lq4/706 with trucknorris cam and then turboed said motor...but also ran e85?
There isn't a tac with dbc... the ecu controls the iac motor so you will need to run wires to it
All p01 had iac drivers. P59s with idle air control drivers for electric or cable operated throttle bodies 12581565, 12576106, 12586243, 12589462 and 12602801
Got it thanks... explains my fueling...wasn't referenced before...
Deka 80s referenced... data says what I entered for ls1 or above that it says 11.744 at 58psi
Did I enter my fuel injector data incorrectly? I am running a referenced regulator...
Should I set it at 11.744g/s across the table?
First thanks to the guys who looked over my 3bar base setup and pointed me in the right direction.
I got it built and took it for the first drive over the weekend.
ive made a couple changes to...
133930
i fattened up the enrichments.
should i increase airmass vs tps under diag section?
For spark plugs... TR6 gapped around 30?
Got it
How rich should I set it?
133857
Hows this?
is the spark still too soft in that area?
I adjusted the EQ for PE and BE. should i leave it flat like that and adjust it later for how boost comes in or will the VE adjust...
Yea I got that IAT to delete the MAF.
T56 trans
I currently have a regulator that I mounted originally by tank so it's not referenced but I can run a longer return line and relocate to engine...
Also this is the IAT I got.
https://www.ebay.com/itm/263120867935
1. Will I need to change anything in the tune for it? It's currently reading from MAF
2. I was goin to put it in the charge...
Adjusted the injector. Anything else i Jacked up?
133838
Ok didn't even think about that... will change it. Thanks
Finally got all the turbo bits for my build and depending on how this week goes gonna have the shop all weekend to install it.
First turbo setup. I started a building a 3bar file but if someone...