From what I believe was done was, the seller that I bought the (USED) E40 from "programmed" using Vin wizard to change the VIN. This was after I had received it and was originally locked with 2006...
Type: Posts; User: Bri'sgoodGM
From what I believe was done was, the seller that I bought the (USED) E40 from "programmed" using Vin wizard to change the VIN. This was after I had received it and was originally locked with 2006...
Believe I found my answer Beta version was blank and the Stable version shows them... Whoops. I'm chasing down a no communication issue originally.
124005
In The DTCs section for both Engine DIAG and Trans DIAG there are a ton of blank spots where specific names of error code were to be. What does this mean?
:banghead:
Long shot here but the truck as been swapped from 3.5l 5 cylinder to 5.3 V8 using 2006 GMC Envoy XL 4WD 5.3 LH6 E40 ECU, VIN changed, went to get it inspected (NY) would not go through...
Everything works as it should after the long pause. Drove the truck tonight and stayed right in the middle around 203-208 degrees. Thank You for your time and patience with me I really appreciate it.
Awesome yeah I have the dual fans so i should be set to try it out.
That'll work excellently, with the resistor that'll be needed for both fans correct? I see it is an available part for purchase locally.
Sounds good, Thank you for your help and patience I really appreciate it. I didn't have this much confusion with my first LS based swap lol. So i will pin into c1-36 c1-56, use the Similar wiring...
Alright understood, Wiring it up i can do, just would the trailblazer programming work the same as the GTO
Alright, so with my current ECM setup it can not be done is what i'm trying to get at.
After looking at a few diagrams there are 3 relays used, one high speed signal and on low kind of like the green and blue connecter on a gen3 pcm besides the 12 key hot, this look constant B+.
...
I have what are the heavy duty dual fans from 08-09 charger. Are controlled by Pcm, variable speeds, and relays are used. Unsure if brushed or brushless were pulled from junkyard. So with my pin out...
Hello newbie to the group!
Have this 2004 Colorado 4x4 build with a 5.3 gen3 using E40 Trailblazer and t42 Tcm. Truck is running and to finalize this build I'm looking into running electric fans....