Search:

i just changed it in the tune ill try it tomorrow and see what it does. and yes the linear and offset are correct for the map sensor.

i am running a 3 bar os with a 3 bar map, removed the maf and added an iat sensor, wired in the sensor and it reads fine but i am having hard start issues everytime i reflash the ecm and its just the...

no knock sensor codes, just maf since im tuning ve right now. any ideas? running fresh 93, i figure with that low of timing running about 12.5 afr i shouldnt see any knock at all. when i tuned the...

ok i will check that tomorrow. thanks!

i just converted my truck to a 3 bar map os, i pulled 5 degrees out of both tables and i noticed today i am getting from 2-8 degrees of knock. currently tuning the ve table. i am new to this tuning...

my 04 lb7 doesnt show a thing for transmission, wont read it or anything. i thought i had a problem with the calibration in the trans so i went to my dealer and both ecm and tcm have the most up to...

while taking time to actually look over everything would my solution be in the "tcc adapt cell preloads"? i am very new to tuning so any help is awesome, i read the description for that table and it...

when driving my truck with converter locked at a constant speed/rpm anytime i get into the throttle it slips a bit but then tcc pressure comes up and it locks up again. i have done research on this...