I'm was told when I change anything in the system options I need to write entire. Is this true or can I write calibration only after changing 1 to 0 under brake torque management on 2004 p59 pcm
Type: Posts; User: 04p59
I'm was told when I change anything in the system options I need to write entire. Is this true or can I write calibration only after changing 1 to 0 under brake torque management on 2004 p59 pcm
I have a 2004 gmc sierra with p59 pcm and i installed a new cluster in the truck that says 140 mph and has a 7000 rpm tach and a transmission temp gauge where my old one didnt. i noticed right away...
swapped a stock lq4 into a 2004 gmc sierra and drove it for over a year now with no issues. i pulled the motor and put a summit stage 1 high lift cam and replaced all gaskets while on the stand. put...
Thats good to know. I know of a fuel station that has e85 about 10 miles from me and was telling him he could pick up a little bit of power if he would run it. He wants me to put a new pump assembly...
Thanks a lot man that was exactly what i needed to know. I will inform him tomorrow and go from there. When the truck was tuned for the cam the tuner never took his top speed limiter completely off...
also the fuel gauge doesnt work in the truck . idk if its a wiring issue sending unit or cluster issue or if its even relevent to the alcohol content sensor
a buddy brought his 2006 silverado over and i data logged it and pulled the tune. it had -19 percent fuel trims and was reading 74 percent alcohol content but he swears he only puts 93 octane in it....
cant find a tune with matching os number. any help would be appreciated. os 12606960
I put a 6.0 in an 04 Sierra half ton and was unable to find a tune with the 4l80e and a matching os number to segment swap my pcm so would my best option be to use the pcm out of a 2004 sierra 2500...
Ok thanks for the replies
Hello. I'm trying to figure out if I can convert a 2004 drive by wire truck to drive by cable and use a 0411 pcm and just swap my Vin number in. Is this even possible. If so can u give me an...
I am having this same issue. I noticed that its only the sensors with (SAE) at the end that do not get logged during stand alone logging but they work just fine with the laptop doing the logging
I am wondering is applying the 2 bar sd enhancement is going to put the truck in speed density mode automatically or will the values in the tables be wrong and in need of adjustment. vehicle is 2004...