Search:

Hi GHuggins,
Yes have to drive the car for about 2 miles and the lights go on. And again no codes read with the HP tuners device. Car runs great no problems other than the light issue. I have...

Hi GHuggins,
So drove the car till the light came on. Checked the fuse box light and was also on . So then I cut the wires to the led light and the fuse box light was still on . Now at this point I...

Hi GHuggins,
Will be trying the light bulb thing tomorrow raining today. Will let you know how it goes.
Can you stop those incompletes from happening in the HP software. If so can you explain which...

Hi GHuggins,

So what you are saying if i change the dast light to a standard light then the MIL light on the stock harness fuse box won't be on either.
I will try that .
Why are those system...

Hi GHuggins,
So I drove the car And the MIL light in the factory fuse box Light was on , as well as the Led dash light. So not a LED light issue.
Just updated the HP tuners software, to Version...

Hi GHuggins,
Thanks for the fast reply and info. Will do that.
I would imagine if I wire in a standard bulb on the same circuit it would give enough resistance so i could still use the Led on the...

Hi GHuggins , Yes there is a light in the fuse block all stock wiring harness .Its a GM crate engine 19332621 and ECU kit 19331517 with drive by wire pedal. The car that it is installed in is a 1987...

Have the Hp tuners MPVI2 . Is there a way to stop this for making the MIL go on in the ECU programing. Has no DTC codes ,

Engine runs fine with the light on. But this is a GM 2016 crate LT4 wet...

New here so, what I need is info how or where to look in the HP Tuner software to adjust the fan temps.

Only using the the stock wiring from the ECU to run oil cooler fans.

So they will...