Any help would be appreciated
Type: Posts; User: NKBALLR
Any help would be appreciated
i am trying to setup this sensor in the scanner for logging trans line pressure. can anyone help me out on what the transform function numbers should be. sensor has a linear output range of .5 - 4.5...
200 & 10.33
I just swapped the 2bar sensor back in it and put the linear number back like it was and map reads 90 and baro reads 104 KOEO, start the car and idle map reads 54-58 like before
Map reads 108 and baro reads 104
I had a gm 2 bar map sensor (part #12580698) installed in the car and at idle it would read 56-58 kpa. I have now installed a LS1 style 3bar map sensor from efi source and now it is reading 65-68 kpa...
if you have already done this then I believe you are having the same problem that I am
1.Key your vehicle into the run position.
2.Connect your interface to your vehicle's obd2 port and to your...
nobody?
does the red error light flash on the controller?
I was able to data log just like normal three weeks ago with no problems, after I got back from the track that day I updated to the new 3.0 and just went to the track for the first time since today...
I would recommend using the LTFT instead. the STFT change so rapidly its hard to get good data, and with your wideband issue have you set it up correctly in hp tuners