Search:

Mornin.

So we have a Redeye that has a built motor, ported blower, cam, 1650s, upper lower, FORE return setup. The issue is a idle drop at the 1 minute mark. Each log, each revision, same drop,...

It says 54% always. At WOT, its 54-54.9% and the injectors take up the slack of the fuel pressure.

So we have a dual drop in setup from Tapped in a slightly modded Challenger. There is a drastic fuel pressure drop when trying to go WOT. Fuel hat removed twice and checked for cracked pumps and...

Hello all. So I have a truck that was built in another shop and ran into tuning issues. We have the engine re-tuned with a new PCM, etc., but the trans will not take a fast learn or slow learn. It...

There are alot of changes in the tune based off what we change for that same cam. Were the IDs needed for future mods? Is the phaser limited or locked? Limited is how we do them. Contact Jeremy...

My MVPI is not reading any longer. It is telling me the vics are unsupported. I re-sync and even entered my application keys and nada...... is it toast?

Hello,

We are having issues with the MPVI2 saying "Vehicle isnt supported yet by VCM scanner." Yet my HPT cable works fine....

2012 Challenger SRT8

The MVPI2 is brand new with 2 credits. We...

New to Dodge.....from the dark side...of LS....haha!

Update. Put her on the lift, found the front mid body brace was rubbing the exhaust, put more spacers on it. Gonna try again.

So what AFR are we looking for on HC's? I am seeing differing...

Morning gents,

So, we just added the 2.72, iD1300x2, offroad mids,Brisk x2 colder plugs. Before the mods, 655 rwhp, 0 KR. After dropped into the 500's and 10+ KR at WOT. Checked everything, added...

Hello all!

So I have added a GC to my group of Mopar. Lol. I am looking for a tune that is just for a stock, un-modded Jeep. Something to pep it up some. I have HPT with plenty of credits....

Following this as I am needing my 148mm TB working!

Hello all. Ron from Texas. Retiring Army. Father of 7. Built and race my 07 MSRT8. Member of the KB 1000 hp club. Lol. I am just learning HPT and so far it is pretty straight forward! I am tweaking...

Hello fellow gear heads. I know that this is a long shot, but had anyone tuned a 4.7 and have the files laying around? I am wanting to tune my tow rig for a few more ponies, and heck, this is safer...

Are you modified? At certain power levels, I wouldn't advise to disable the torque management. I have done that and had to go back and re-engage the setup.

Hello all.

Ok, so I had my TCM tuned with HPT before I switched over to HPT. It was all good, shifting @6800 every time. Once the switch and ECM tune was done, the TCM basically "bricked". It...

I am tackling this monster now. We are adding more torque management on the 3-4 shift as this is my problem area. The shifts are neck snapping and tend to break the input shaft. So we are reducing...

Bad AS*! I think I need to make the switch to HPT.

Looks like I may be giving HP a shot on my set up. Maybe this can calm down the 4.2