Search:

Type: Posts; User: RickClarke23

Page 1 of 7 1 2 3 4

Search: Search took 0.00 seconds.

  1. Yes sir I moved them one at a time

    Yes sir I moved them one at a time
  2. Thanks Murfie. I got back on the dyno today. I...

    Thanks Murfie. I got back on the dyno today. I corrected the maf error to within 2% and got the spark to hold out 30.5 to 7800. I made the most power (493) with the stock VCT settings. Peak was 6700...
  3. I did not but I sure can

    I did not but I sure can
  4. Here was the VCT settings I used

    Here was the VCT settings I used
  5. 2018 A10 With CJ setup and Monoblade VCT Settings Dyno Numbers

    Got a good Deal on this setup and threw it on my 2018. Previous mods were JLT Cold air Headers and E85 with a Drag Pack. Car ran great and makes 471 with those mods. Baseline when stock was 398.
    ...
  6. Replies
    1
    Views
    351

    2uz-fe 4.7L toyota support

    Hey any plans on doing support for the 4.7 in the tundra etc, I have a couple that need to be tuned here locally and I just wanted to check before sending them elsewhere. Thanks
  7. Replies
    13
    Views
    567

    what cooling mods do you have because on the log...

    what cooling mods do you have because on the log your blower temps are getting high enough to hurt power output greatly
  8. Replies
    45
    Views
    2,396

    Had the same problem with A customers car but my...

    Had the same problem with A customers car but my personal car does not do it. His car even did it with the stock tune. It was mostly his bank 1 VCT that would go crazy and cause the car to die...
  9. Replies
    4
    Views
    825

    Need to raise all those and also transfer case...

    Need to raise all those and also transfer case protection and also all the ones you mentioned plus al the ones under trans ipc
  10. You need to go to engine-fuel-transient-transient...

    You need to go to engine-fuel-transient-transient fuel qualifications and under min fuel milligrams lower it to zero. This is more than likely keeping your injector PW high at idle.
  11. try this file and let me know if it still does it.

    try this file and let me know if it still does it.
  12. any update on the transbrake feature?

    any update on the transbrake feature?
  13. Replies
    87
    Views
    9,019

    I hadn't been having any trouble and now I am...

    I hadn't been having any trouble and now I am after the firmware update a bit ago. Bought 2 separate orders and no resync yet
  14. as far as boost control I have had similar...

    as far as boost control I have had similar problems and had to go to a c02 system to hold the gates shut
  15. that has to be actual detonation. try pulling a...

    that has to be actual detonation. try pulling a degree or two there.
  16. when you say you could see Something coming out...

    when you say you could see Something coming out of the tailpipe what was it? puff of black smoke?
  17. Replies
    9
    Views
    1,404

    you will need the newest version to open it

    you will need the newest version to open it
  18. OK so honestly the log looks pretty good. I just...

    OK so honestly the log looks pretty good. I just finished up a 17 Whipple Zl1 also that was pullied for 16psi. On 93/meth it runs more timing than you are around 17*. On e85 (flex fuel) we are around...
  19. Replies
    9
    Views
    1,404

    try this file

    try this file
  20. post a log

    post a log
  21. Replies
    17
    Views
    1,573

    same here any update on this?

    same here any update on this?
  22. you should just need 2 credits for the ecm. Not...

    you should just need 2 credits for the ecm. Not sure if he tuned the trans also.
  23. Replies
    78
    Views
    15,386

    ok so yes the Bluetooth is working on the scanner...

    ok so yes the Bluetooth is working on the scanner but I am unable to read a file out on the editor. Not a big deal but the editor is not recognizing the MPIV2
  24. Replies
    78
    Views
    15,386

    im sure it will be fixed soon probably a firmware...

    im sure it will be fixed soon probably a firmware problem/bug. Just wanted to make sure it wasn't just me. Thanks
  25. Replies
    78
    Views
    15,386

    exactly it may be on my end but I am pretty...

    exactly it may be on my end but I am pretty computer savy and in my Bluetooth searches with the Bluetooth light blinking neither one of my laptops can find the device.
Results 1 to 25 of 161
Page 1 of 7 1 2 3 4