Search:

do you have to log both banks to be accurate?

Check you PE EQ table and PE TPS enable tables.

Well long story short my interface went out completely and im unable to get vcm suite info log while connected as requested by support@hptuners. How do u get the vcm info log while not connected? I...

what vehicle is this on? I was had that issue once but it was only with a beta version. Once i got another one it was fine or if i used 2.22 it was ok.

same thing happened to me but i ordered some cables as well. Good to know im not the only one it happened to. Never got an email confirmation or new key, however i was charged for it.

i've messed with these tables and in some cases it frys it immediately, in some cases in takes a while and in other cases nothing happens at all. The difference is definitly noticable. I was having...

There is speed density closed loop and speed density closed loop. I personnaly use SDOL cause i use racing fuel and a good amount of nitrous. Its keeps things pretty much set and there is less...

Change your stoich, Change your setting to 100% maf calculations. Your narrowbands recgnize lambda 1 so if u set ur stoich properly the trims should be good. The reason i use 100% maf is to avoid...

What do i need to do to find out if there is? THe file is from an 05 express van and i want to use one from an 05 silverado. Im doing these crazy experiments on my truck and converting it to cable...

I know most segment swaps for transmission are to convert to like the 4l80 but can u convert an hpt file that already made for the 80 to a 60 segment swap. I have a file i need this done to.

Your NB o2s are good at lambda 1 which is the optimum effeciency but it varies for different fuels. So the o2s measure byproducts to attain stoich so if you set ur stoich correctly for E85 you...

change it to calibration.

Just put a value like .25 cause if you smooth it the values would be like .00xx and that would not be enough.

That looks awesome

Ok thanks.

Ok i've been waiting on support to send me the latest beta version and also i sent some info they requested to be able to edit a 2010 camaro. I've sent the info twice from two seperate e mails and...

Found the problem it was my beta version. I hope this helps someone someday.

Im tuning a 2008 silverado and for some reason the tps opens and closes with the peddal depressed 100%. as far as i know ive gone through cancelling the torque management and traction control on the...

I don't much about your set up. Does your vehicle run a MAF and VE for fueling calculations under a certain RPM? It looks like your VE is off. Have you calibrated the VE? Can you run MAF...

Yeah :secret: I really like it and for some reason it feels much more effecient.

im running mine on corn lol it feels alot better.

Finally had some good weather here in south texas and ran a 12.94 @ 107.94 1.97 60ft with catless, x pipe and tune. Not bad for the mods. This was in 60 degree weather.

The link above is for running different fuels. There was another thread where this guy was using a resistor at the IAT signal which would trick the computer to be at like 20degrees and then change...

What i've noticed is that they don't like as much timing. You'll be lucky to run 23 degrees of timing on them depending on your CR. The 6l80 tranny is also very different i've stuck to just moving a...

you have to load your tune and disconnect the battery for a little while then it should work good. Don't ask me why but it works.