Search:

I've never seen much of a gain on 5.7s after 24 degrees on E85.

Did you check for power and ground at the CKP connector?

The fix is in the injector data

And this is why rookies come in here and get nothing but crickets. The forum didn't create the drama btw.

SOunds like your upstream o2 sensors are upset. Make sure your upstream o2s are reading correctly and not dumping fuel to one of the banks unnecessary

OP, you might wanna listen and try what they are offering.

I am in no way defending this tune. Could it be better? Of course. Any seasoned tuner would agree. I'm just not into slamming other tuners for their product.

I agree with edcmatt, way too high of an idle for that cam. I would typically set that combo to 800-825 RPM.

I just took a quick look. Tune doesn't look bad IMO. I always give vehicles that I tune a quick check up on the road after the dyno, before I call it good. I can't stand it when idle dips low when...

No reflash should be needed. Just swap sensors and HPFP over, and she should fire right up and be happy.

It should run okay with those mods and a stock calibration. Something else is up. Please elaborate on the situation with this car. Was it demodded? Was it bought at an auction? Etc

I've seen minimum spark set to full ignition timing in some tunes i've opened. Yikes.

You may also want to revisit your minimum spark table. Not enough negative spark in those tables, which is contributing to a very slow return to idle.

I will give you a hint, the fix is in your throttle map. Hope this helps

Unplug the battery for 5 min. Then try again. Should write normally after that

Segment swaps are the way to go, this way even VT and VVE gets easily emulated

Im sure if you post the tune, someone might help and send you a bare minimum tune to get the truck running.

Trust me, just do an L83 or L86 swap and segment swap the PCM. You'll be thankful you did.

Load this up. The 06-07 E38 for whatever reason hates the wheel hop TQ management and almost always interferes once the car is modified. I felt bad, so I also added a better timing table for you to...

Look at map points used on the S197, and tune it like you would tune a GEN 1 Coyote

What type of supercharger? That makes a huge difference.

I usually run 14-16* on 91 octane and about 8 psi for these older 5.9s

You can also try by adding 15-20% to the cranking fuel table in the warm areas.

If you're desperate, run in open loop and lean out the idle areas you want more chop from. Or you can do it the right way and get a higher stall converter.

Post your stock tune and list of mods, and someone may help you.