Thank you so much for taking the time to write this out and helping me.
Type: Posts; User: Darrell23
Thank you so much for taking the time to write this out and helping me.
I changed min fuel mill to .010 That immediately leaned out the idle an had to pedal it to stay running, Before I could just hit the key and it would start and stay running. I think the ve table...
Yes it was set to manual trans in my original tune. The speedo is way off in the log file.
where do I find my in gear cut off so I can change it?
I have the siemen deka 80 and I put in the correct...
Can you take a look and see if im going the right direction on my tune. I have been working on my ve table for a while. im using afr err histogram and I have copied and pasted about 20 times its...
I got the new EFI map installed and made all the changes that you suggested. I didn't get to drive it yet but I did log a cold start. I'm having trouble with my chart vs real time not reading wbo2...
Awesome,, Thanks
Does any one have the correct calibration numbers for Efi source 3 bar map sensor. Ls1 style if that matters.
Thanks, I just ordered one from EFI source.
As far as the ve table after I copy a stock one like you talked about in post 2 should I take some fuel out at idle for the cam and add some in higher...
Do you have any recommendations on a 3 bar map sensor, the ones from summit and Gm direct are both 100$ I chose the one that I have because it fits in the truck intake like the stock sensor does.
My...
I am using a smart fire 3 bar map I got off ebay. I have been second guessing my self about getting one off ebay. It came with a calibration sheet but I’m not really sure how to get the proper linear...
Hello There, This is my first time tuning with hp tuners. Can some one with some experience take a look at it and let me know if its good enough and safe to start tuning with wb02. Let me know if I...
Hi there Im hoping someone can help me out.I just installed my wb and used the egr circuit and installed the pins 55,41 in the blue connector. I Had it set up and the voltage seams to be correct the...