Search:

Type: Posts; User: wasyl

Page 1 of 7 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    336

    you can only see alcohol % in fuel in Scanner....

    you can only see alcohol % in fuel in Scanner. Also there are two kinds of Flex sensors, one is physical and "second one" is only math parameter. Both give same result of alcohol % in fuel. I always...
  2. Replies
    1
    Views
    421

    today it started to work propperly best regards

    today it started to work propperly

    best regards
  3. Replies
    1
    Views
    421

    Problem with Capcha and conntact form

    When trying roder licences i got message that Captcha is incorrect but there is no field. Tried oin two different PC's. Same on Contact page, it asks o input but there is no field for it and to...
  4. Replies
    0
    Views
    112

    E38 PCM with LS1 injectors

    I did 5.3 swap using ls1 injectors on E38 POCM. Does anyone know to modify E38 injector tables in PCM when ls1 installed ?
    In "how to thread" is a dead link to universal injector spreadsheet :(
    ...
  5. Replies
    10
    Views
    600

    leave MAF calibration stock and just play with...

    leave MAF calibration stock and just play with VVE, had same issue when swaping stock 5.3 to other car. For unknow reason PCM is not able to work propperly in SD/MAF mode, but in only MAF or only SD...
  6. Replies
    0
    Views
    124

    PCM for spark only control

    I'm goin' to carb 5.3 engine and need to control spark somehow. I do have spare PCM (HPT unlocked already) and engine harneess and was wondering if it is possible to run it in SD mode for spark...
  7. Replies
    43
    Views
    15,524

    good to know best regards

    good to know

    best regards
  8. Replies
    43
    Views
    15,524

    yes, with this PCM all You need is: - stock...

    yes, with this PCM all You need is:
    - stock harness repin
    - fuse/relay block
    - front o2
    - accelerator pedal
    - 2014+ TB + connector
    Starter relay can be hotwired or PCM controled.
    Some say that...
  9. Replies
    43
    Views
    15,524

    seems so. Syked Ecu Tuning told me he is able to...

    seems so. Syked Ecu Tuning told me he is able to remove it but never tested him, i'm international so i preffered to get factory unlcoked PCM with no SKIM

    best regards.
  10. Replies
    43
    Views
    15,524

    yes, plus a bit of repinning wiring but is the...

    yes, plus a bit of repinning wiring but is the easy one! 2014+ TB has different connector too. Or swap whole harness with all modules, dash, ignition lock cylinder, shifter etc. etc. form a donor.
    ...
  11. Replies
    9
    Views
    734

    i had issue once with 2001 Vette. for unknown...

    i had issue once with 2001 Vette. for unknown reason radio communication link on DLC burnt my HPT and had to send it for replacing it. from that time on any Chevy if i wan't t work with Chevy i do...
  12. Replies
    43
    Views
    15,524

    update, this PCM requiers newer type of throttle...

    update, this PCM requiers newer type of throttle body form 2014+ hemis, also PCM is factory unlocked so no need to send it for unlock service. just licience it and ready to go.

    best regards
  13. Sticky: Thanks a milion! best regards

    Thanks a milion!

    best regards
  14. Sticky: Does anybody know if Mopar Performance PCM like...

    Does anybody know if Mopar Performance PCM like P5160105 (5.7 Hemi Crate Motor) needs unlocking service or not? On HPT Supported Vehicles List page -> Mopar Performance there is no notes mark, does...
  15. Replies
    11
    Views
    922

    most important it has no SKIM (and other...

    most important it has no SKIM (and other anti-theft) in it and does not need all that BCM, RFA and other crap from stock car to start the engine, starter relay gets hotwired rather then controled by...
  16. Replies
    11
    Views
    922

    i have managed to read it ok, it was GPEC2A. HPT...

    i have managed to read it ok, it was GPEC2A. HPT Editor showed some message that this is 2015+ PCM and it is locked but i don't know how to chceck wether Mopar Performance PCM are locked or not. I...
  17. Replies
    11
    Views
    922

    Thanks, will check that one tomorrow morning. ...

    Thanks, will check that one tomorrow morning.

    best regards
  18. Replies
    11
    Views
    922

    this is the one from that crate kit. i'll try to...

    this is the one from that crate kit. i'll try to read as GPEC2A then, with GPEC2 it takes 10 minutes and says some crap after trying to open it so i wanted to confirm which model it is.

    best...
  19. Replies
    11
    Views
    922

    PCM type to recognize

    Can anybody tell me what kind of PCM is this Mopar Performance PCM PN: P5160105 ( https://www.jegs.com/i/Mopar-Performance/312/P5160105/10002/-1 ) i would like to read it, but as it does not have VIN...
  20. Replies
    50
    Views
    22,839

    dig up. I just did swapped 5.3 (A4 PCM and TCM...

    dig up.

    I just did swapped 5.3 (A4 PCM and TCM but use 4L80E instead 4L60E) form 2007 Tahoe 4x4 and working to use stock 1996 Impala SS speedo. Do i get this right that i use PIN 57 on X1...
  21. Replies
    43
    Views
    15,524

    well i did not manage to remove SKIM as is, but...

    well i did not manage to remove SKIM as is, but found a walkaround that works for me. I bought MOPAR PERFORMANCE PCM p/n P5160105 form Jegs, only supplier to sell this PCM seperatlly from MOPAR...
  22. Replies
    6
    Views
    479

    Stock VE (IMRC open and closed) tables were...

    Stock VE (IMRC open and closed) tables were empty, and i could not find VVE table.

    beest regards
  23. Replies
    6
    Views
    479

    Thanks a milion. Now if i set table in scanner...

    Thanks a milion.

    Now if i set table in scanner of math parameter LTFT+STFT, rows and colums linke in VE table, will that work correctly with NBo2 to adjust table for cruise ? For WOT i know i need...
  24. Replies
    6
    Views
    479

    5.3 2007 SD tune non boosted

    Does anybody have any good starting point VE table for 5.3 form Tahoe on E38 PCM, 2bar SD OS, totally stock engine? Tried Tune Repository but no luck, also did not found on board.


    best regards
  25. Replies
    8
    Views
    1,139

    that is correct best regards

    that is correct

    best regards
Results 1 to 25 of 157
Page 1 of 7 1 2 3 4