Search:

Type: Posts; User: BlownGS

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    5,162

    VID block is written from factory so diff gear...

    VID block is written from factory so diff gear changes or revolutions per mile aren't seen by the car. Using VSS by PCM reads speed off the wheel sensors
  2. Replies
    9
    Views
    5,162

    I'd still try this method misk. Its changes the...

    I'd still try this method misk. Its changes the way the car reads road speed so should automatically recalibrate for your ratio change
  3. Replies
    9
    Views
    5,162

    In the speedometer section disable the tab sayin...

    In the speedometer section disable the tab sayin use VID. your changes for rolling diameter will then be used.
    Then select VSS out by PCM. that's how I changed mine
  4. Replies
    105
    Views
    119,271

    Is there an option to send it to your Australian...

    Is there an option to send it to your Australian supplier for this to happen? Or is it only via the address you've supplied at this stage
  5. Replies
    10
    Views
    5,589

    There is a version of the FG MKII hims that cant...

    There is a version of the FG MKII hims that cant be flashed or they will brick. This info came from an ex Ford tech that I know
  6. Replies
    10
    Views
    5,589

    You'd think so. But unfortunately they usually...

    You'd think so. But unfortunately they usually get taught this is the only way to use the software. I've had the FPV shift alert enabled on my car most dealers I spoke to said it cant be done. Any...
  7. Replies
    10
    Views
    5,589

    Tell ford to remove the fuse for the HIM connect...

    Tell ford to remove the fuse for the HIM connect with IDS and go into module programming. Then select install new module. It will ask if the module is still in the vehicle say no then it will ask to...
Results 1 to 7 of 7