Search:

Type: Posts; User: scr71822

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    116
    Views
    126,913

    I have the new lower temp thermostat and my trans...

    I have the new lower temp thermostat and my trans runs at about 145 deg F, I don't think it will ever hit 70C to run this.
  2. 2016 Silverado 6spd Disable DOD by trans gear

    I've been playing with my convertor lockup and trying to remove some of the annoyances with v4 to v8 mode in part throttle cruising. Is that possible? I know you can do it by MPH.
  3. I've raised my TCC Apply up about 6 Mph for each...

    I've raised my TCC Apply up about 6 Mph for each gear so that it doesn't interfere as much with V8 to V4 transition in part throttle. I also disabled lockup completely in 1st and 2nd gear.
  4. Replies
    6
    Views
    6,017

    Your IAT temps were way up there, was that on a...

    Your IAT temps were way up there, was that on a Dyno or were you driving? Definitely losing some timing at those temps. Coolant was over 223 and your Trans was well over 200 as well. Fans are...
  5. Replies
    7
    Views
    3,600

    File size is a lot smaller than my 2016 Silverado...

    File size is a lot smaller than my 2016 Silverado which is normally 1.4 MB for ECM and 2.1MB with the TCM. Looks like you pulled only the TCM.
  6. Replies
    2
    Views
    4,265

    I just converted my 2016 to burn E85, and have...

    I just converted my 2016 to burn E85, and have been tuning it for that so, welcome to the club. If your truck is not already E85 capable, I would do that, but I thought I heard all 2014's were.
  7. Replies
    7
    Views
    3,224

    I have a Hypertech Max Tuner 2.0, I applied that...

    I have a Hypertech Max Tuner 2.0, I applied that tune, this adjusted the spark, but I have yet to adjust fuel yet in either PE or open loop.

    It feels good, but don't have access to a dyno.
  8. Replies
    7
    Views
    3,224

    To answer your question though, I believe only...

    To answer your question though, I believe only the Flex Fuel Sensor enabled, Stoich updated, MiL and codes enabled in the ECM, all the other tables are the same, at least in my 2016 that was the case...
  9. Replies
    7
    Views
    3,224

    Are you taking about the Power Enrichment tables?

    Are you taking about the Power Enrichment tables?
  10. Replies
    46
    Views
    20,195

    Enquiring minds want to know...

    Enquiring minds want to know...
  11. You are right I got another from them as a...

    You are right I got another from them as a replacement after spending $60 bucks on it. It is poorly designed and is open partially all the time it appears even when it is sitting on the bench.
  12. Replies
    46
    Views
    20,195

    Does this occur in V4 mode or V8 mode or both?

    Does this occur in V4 mode or V8 mode or both?
  13. It is definitely not OEM quality. On the stove...

    It is definitely not OEM quality. On the stove it did look to start opening at 178 by my meat thermometer which is probably not the most accurate. Its probably opening closer to 172 by the way the...
  14. Stock is 207

    Stock is 207
  15. On the stove it was opening before 180.

    On the stove it was opening before 180.
  16. I tested it in water on the stove before I...

    I tested it in water on the stove before I installed it. its definitely not stuck open. I am also running water wetter with my antifreeze. The previous 180 stat I had, the gasket failed and it was...
  17. I installed the Mishimoto 180 degree thermostat,...

    I installed the Mishimoto 180 degree thermostat, and I don't think it will be hot enough in northern climates in winter. It was 73 deg and sunny today. The truck only managed to hit 180 after a...
  18. I got my Mishimoto 180 degree thermostat today so...

    I got my Mishimoto 180 degree thermostat today so I will be installing and playing with the fans.

    I tested it in water and I saw it start opening about 178 degrees, appears to be fully open by...
  19. Replies
    19
    Views
    6,460

    Yes I already have mine set to sensor with 70.6%...

    Yes I already have mine set to sensor with 70.6% Ethanol. What I was referring to was the Hypertech tune Which Leaned out the Power Enrichment for GAS only not the Alcohol table.
  20. Replies
    19
    Views
    6,460

    I have a 2016 Silverado 5.3 installed the sensor....

    I have a 2016 Silverado 5.3 installed the sensor. I have the hypertech max energy 2.0 tune for high octane (93) it enables enrichment to start at 4000 rpm and it actually leans out the EQ Ratio...
  21. What would the effect be to zero out the State vs...

    What would the effect be to zero out the State vs Desired % like the Camaro I posted earlier?
  22. 88429

    88429
  23. I got another question for you, I've been playing...

    I got another question for you, I've been playing around with the Desired ECT at 208 stock is 221.

    This with no other changes, what effect would it have, would it force the ECM to try to adjust...
  24. I'm starting to work on a 180 stat profile for...

    I'm starting to work on a 180 stat profile for when my new one arrives.

    88413
    88414
    88415
  25. So I'm curious now, how would the AXIS change...

    So I'm curious now, how would the AXIS change affect your thoughts on adjusting the Desired % for a stock 207 thermo?


    Also kicking around changing the ECT Override to 224

    I am looking at...
Results 1 to 25 of 37
Page 1 of 2 1 2