Engine side is all Corvette and we put all truck stuff on the transmission side seeing if that would work?
Type: Posts; User: CanadianLS1
Engine side is all Corvette and we put all truck stuff on the transmission side seeing if that would work?
Yes, we have even tried copying all transmission settings from the stock truck tune to the corvette tune file. With no positive effects.
Hey everyone.
i got a buddy that did the 896 pcm swap in his 98 vette. The pcm came from a 2000 silverado 2500.
His issue is when he flashes the corvette OS to the 896 motor and everything...
You can use the egr port like stated previously. 0411 is pin 55... I know 97/98 corvettes are pin 8 or 9 i wanna say.
I have the math for a aem ugeo 4.2lsu
Hello,
So i just finished a few upgrades and I've been watching goat garage, I followed rinkrat456's idle tune write up. I did both these as best i could, But i feel its not even close. Looking...
Thanks for the reply. This is just the map that was in the car, All I did was rescale for the 52lb injectors. Any suggestions or where to start?
my math is in AFR as thats what was easiest to figure out. But converting to lambda wont be hard.
in the expression i have " 2.3750*[7101.10]+8.7214 "
using ac pressure switch.
you need to set up your math parameters. What wideband are you using?
I just wired mine in through the ac pressure sensor(5 volt sensor) i could help you with this.
Recently bought HP tuners. and looking at dialing it in a little bit.|
I have a 1997 corvette with a LS1
Mods:
Tr6 plugs(gapped at .036")**new wires aswell*
Ls6 intake manifold
Ported...