Search:

Type: Posts; User: outlaw_50

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    147

    thanks .. hope you enjoy your car !

    thanks .. hope you enjoy your car !
  2. Replies
    5
    Views
    142

    Check your fuel trims, then adjust accordingly

    Check your fuel trims, then adjust accordingly
  3. Replies
    17
    Views
    3,767

    I connect the Intercooler pump directly to the...

    I connect the Intercooler pump directly to the fuse box so its always on when the switch is in ON position.
    That's the best way in my opinion
  4. Replies
    2
    Views
    74

    use Type 6 to remove MIL light

    use Type 6 to remove MIL light
  5. Replies
    17
    Views
    3,767

    Easier is to just to make it always pumping by...

    Easier is to just to make it always pumping by making the intercooler pump directly connected to the switch ON position.
  6. Its doable but not with hptuners

    Its doable but not with hptuners
  7. Replies
    3
    Views
    147

    Check your PM

    Check your PM
  8. Replies
    17
    Views
    3,767

    3EE392 => Upper Threshold IAT for Activation...

    3EE392 => Upper Threshold IAT for Activation intercooling pump

    3EE394 => Lower Threshold IAT for Activation intercooling pump

    3EE3A4 => Upper Threshold Transmission oil temp for Activation...
  9. Thats because you are using usb 3.0 cable on a...

    Thats because you are using usb 3.0 cable on a usb 2.0 port (on your laptop)

    just use another cable
  10. Replies
    4
    Views
    329

    1- Fuel System -> Fuel Pump 2- Fuel System ->...

    1- Fuel System -> Fuel Pump
    2- Fuel System -> Fuel Pressure
    3- Engine -> Fuel -> Inj Pulse
    4- Engine -> Fuel -> Max inj
    5- If your looking to fine tune (Closed Loop) , Engine -> Fuel -> Oxygen...
  11. Replies
    4
    Views
    329

    Fuel -> Temp Control -> Target Lambda

    Fuel -> Temp Control -> Target Lambda
  12. Replies
    4
    Views
    501

    Damos + winols

    Damos + winols
  13. Replies
    13
    Views
    557

    use cylinder airmass instead of aircharge

    use cylinder airmass instead of aircharge
  14. Replies
    13
    Views
    557

    use the previous version if its working

    use the previous version if its working
  15. Replies
    7
    Views
    537

    Pull the anti-lock fuse (abs fuse)

    Pull the anti-lock fuse (abs fuse)
  16. Thread: Knock

    by outlaw_50
    Replies
    5
    Views
    492

    The way I go about is I make a histogram for each...

    The way I go about is I make a histogram for each cylinder.

    I've attached a histogram as an example for logging knock in cylinder 1
  17. Replies
    6
    Views
    727

    Did you add EQ Ratio Error as your input sensor...

    Did you add EQ Ratio Error as your input sensor in the MAF Histogram?
  18. Replies
    2
    Views
    819

    You meant that you need the sound of the Hard Cut...

    You meant that you need the sound of the Hard Cut Limiter (Cuf-Off)

    Its under Fuel - General - Hard Limiters:

    Adjust RPM Fuel Cut + RPM Fuel Restore
  19. Replies
    1
    Views
    537

    I could help you with that

    I could help you with that
  20. Replies
    7
    Views
    2,532

    Here you go !! 2014 Range Rover Sport (ECU...

    Here you go !!

    2014 Range Rover Sport (ECU only didn't read TCU)
  21. Replies
    5
    Views
    1,794

    Here you go !! Its better to have cats delete...

    Here you go !!

    Its better to have cats delete though ..
  22. Replies
    2
    Views
    502

    You can change them all .. if your not sure what...

    You can change them all .. if your not sure what is what !
  23. Replies
    9
    Views
    2,942

    Your throttle shuts of because of boost limit,...

    Your throttle shuts of because of boost limit, just raise Max Overboost (ECM 11279) to 2.5 psi,
    then to maintain boost and hold it much longer increase Torque to Load in the range of 70-80% at 4500...
  24. Replies
    1
    Views
    893

    They control how lean or rich the mixture is in...

    They control how lean or rich the mixture is in Closed Loop.

    The (voltage supplied) to the O2 sensors determines if its rich or lean, The closer you are to 0 the leaner the mixture is.

    Its good...
  25. Replies
    17
    Views
    3,767

    The map is available in Damos

    The map is available in Damos
Results 1 to 25 of 30
Page 1 of 2 1 2