Right, thank you so much!
Type: Posts; User: gohanet
Right, thank you so much!
Thank you very much for your help! And Enable delta cyl air make all 8, 8 is mg?
Hi, everybody.
Please help, I have 5.3 LM7, turbo s475, deka 80s, 43.5 psi 1:1 fuel regulator, methanol injection(Yes by this AFR is rich because of it, I'll fix it).
Today I made 3 runs on Dino...
310 when cold, when fully warmed up the engine after a drive 20-32. When fully warmed up the motors without drive 70-90
.
What does it mean when the engine is cold?
I know this, but the question is a little different, what is the normal maximum value should be when the motor warms up?
My firmware is almost entirely customized by me, thanks to your forum, but except for IDLE.
I read a huge number of messages here on configuring IDLE, but all exactly not until the end of...
I think I found a problem. When starting the engine ECU asks AFR 23.9583958
I have a question, where to adjust this parameter?
Thank you! Thanks to your values, I now have the MAP showing 99KPA correctly with the engine off. I corrected the settings and went out to AFR 13.5. But I also have a problem that the engine itself...
I set the MAP sensor settings on
MAP Sensor Linear: 329.41
MAP Sensor Offset: -6.35
The AFR has become a 13.3 engine that seems to have become more stable, but it doesn?t want to wind itself up...
It seems that I have an error in the settings of the MAP sensor. If you believe the data on this site here https://sites.google.com/site/sloppywiki/everything-ls/gm-map-sensor-identification then...
I have is worth MSD sensors 2313 https://www.summitracing.com/int/parts/msd-2313/overview/
Its setting Offset:10,33 kPa and Linear:305 kPa.
My tunes 83897
When working at the motor AFR 11.6-12.00....
I have an IAT sensor installed. Here attach the log file where the engine is turned on only 3 attempts and then when I push the accelerator pedal.
As I tried to adjust the IDLE as the manual...
Do I understand correctly, if I have a fuel pressure of 58 psi and the injectors are calculated 84.32 lb / hr @43.5 psi, then I need to table HPtuners "Injector Flow Rate vs. KPA VAC " set the value...
If someone can, please check my setting, as I did it myself the first time.
The problem was found. I mixed up the wires on the injectors and the ignition coils. The engine now starts and runs. But walk idle. Firmware I myself altered, read the manuals and did.
The vehicle theft system is down. O2 is not installed on the car, the setting will do without them, I have AEM broadband.
Sometimes the engine can start for 3-5 seconds and then immediately stalls....
Hey. I'm building a Mustang with an LM7 engine.
Today, all installed, but the engine does not want to start.
At the factory the engine sneezes. Got a spark.
My specification: 5.3 lm7, S475, no...