Search:

Re: I see some guys saying they see v1.7 in their downloads page but not 2.0. I dont even have 1.7 on my downloads page, i have it on cd, but arent i supposed to have it on my download page??
...

Question for all? If tuner has locked a PCM and has gone out of business are there other methods of getting in if so how? Pm's most welcome a freind of mine is in this situation and we would at least...

Vehicle in question is a Holden Crewman..

Hi all quck question.
In regards to Max Line pressure can this be increased above 96 also Base Shift Pressure vs Torque vs Gear can this also be increased above 96. We were playing around with my...

Mine has the Electronic Throttle Control. Tried it this morning on a partially wet road. Results are better than the factory setting. Factory setting is a bit much on the agressive side. Factory...

Just an FYI i tried the above settings. Found Traction control to function quite nice. Not as intrusive as the stock settings. Gave it some gas around a corner slowed the vehicle down quite nicely...

On a side note Gday Stu.. When are you back at work?

Thanks for your reply Arron appreciate your response.

Regards

Can someone throw some information my way. How do you make the vehicle switch to the high table?
Knock Learn Factor (If it's 1.00 then you're on the high table and 0.00 is low)
What needs to be...

Can i have a copy of the above ;D Shouldnt be to far i hope..

Hi EpOcH you are correct wrong config file. Re loaded default and all was fine again.

Regards

All sorted. No replies required.

Regards

Ran some scans today not sure what the hell is going on.
Is it something i have done or something wrong elsewhere mechanical electrical.
My 02B2 isnt registering at all stays on 0 my INJB2 isnt...

Hi Ross thanks for your reply. I have two bin files which were provided to me. They are for my VZ SS M6 and i have one for the 4sp Auto which we will be using on my mates VZ Crewman SS. I will check...

Thanks for your prompt reply rattle. Agree with your rule. I need to start somewhere I asked for these so i can compare stock with modified. Basically i want to use these as a template. So just to...

Hi all im new here from Australia. I will be picking up my software tommorow ;D and looking forward to a new learning curve. My first question is as follows. I have been provided a couple of bin...