Search:

Type: Posts; User: c2vette

Search: Search took 0.00 seconds.

  1. So for what it is worth, so far using the switch...

    So for what it is worth, so far using the switch on the control circuit to activate the 2nd stage does not set any codes and none stored. I have limited my "experiment" to no more than 5 minutes...
  2. ...and no way to actually disable the diagnostic...

    ...and no way to actually disable the diagnostic I assume, so back to square one. When I was testing out the switch and driving with the second stage enabled (i.e. no power to solenoid) I did not get...
  3. Replies
    13
    Views
    31,345

    Sticky: If you have a DTC that does not result in a...

    If you have a DTC that does not result in a permanent code, but does cause vehicle to go into "limp mode" until cleared, will unchecking the box in the table and setting to "no error reported" affect...
  4. Question regarding the simple notion of running a...

    Question regarding the simple notion of running a switch on the solenoid control wire. I have that set up, and it works as expected.

    My question is will setting the relevant DTC (which normally...
  5. It is easy enough to disable the DTC so as not to...

    It is easy enough to disable the DTC so as not to be annoyed by that, so that is probably the route I will go (manual control) unless someone offers a clever option.

    Would also be OK to just lower...
  6. Controlling dual stage oil pump in 3.6 HFV6 LGZ

    I would like to be able to control the operation of the dual stage oil pump in my supercharged Canyon so that it comes on under certain boost conditions.

    At present the factory programming shuts...
  7. Thread: 8l45 tune?

    by c2vette
    Replies
    14
    Views
    12,158

    Stock 2018 Canyon tune

    Here you go this is stock 2018 GMC Canyon V6 SLT - Edit: Oops I just realized you wanted TCM, I am sorry but I needed to get a code from HPTuners to unlock the TCM in order to read it and did not do...
  8. Thread: 8l45 tune?

    by c2vette
    Replies
    14
    Views
    12,158

    I am installing the Mallett supercharger within...

    I am installing the Mallett supercharger within the next couple of weeks, but will be doing and entire read of the stock tuning prior to sending my ECM to Mallett. If this is still of any use to you....
  9. Thread: CASE Relearn??

    by c2vette
    Replies
    25
    Views
    38,256

    I know this is old, but since I finally got it to...

    I know this is old, but since I finally got it to work thought I would share my experience. Using an E67 ECU with a 2008 5.3l engine swap.

    No code, but figured I should do the CASE relearn since...
  10. Replies
    15
    Views
    9,698

    Man I cannot thank you enough for discovering and...

    Man I cannot thank you enough for discovering and posting this Trans Abuse setting table. I have an S10 with an LS engine using an E67 from a 2008 Trailblazer. After finishing up the swap a month...
  11. Replies
    122
    Views
    50,186

    4000 rpm?

    I bought the VCM Suite mainly because I wanted to throw a few more $$ into the pot for support of the HHR SS. Reading the tables is pretty interesting, but not about to mess with anything of course....
Results 1 to 11 of 11