Search:

Type: Posts; User: Volstang

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    519

    Turn off DFCO, set Disable Load to 0 and in MBTs...

    Turn off DFCO, set Disable Load to 0 and in MBTs used for decel set top two rows (lowest load) to 5.
  2. Replies
    3
    Views
    115

    Here you go

    I have one for the 3.7 but its an auto. Tuning the manual is much easier though, you and increase the numbers for each gear in the upper rpm range for each gear. (2 far right hand columns) Increase...
  3. Replies
    2
    Views
    120

    These tune up very similar to Coyote. Increase TQ...

    These tune up very similar to Coyote. Increase TQ mgmt stuff, add spark in MPs, change target lambda, and on the trans you can increase shift pressures in upper torque (WOT). Same type stuff you do...
  4. 105mm MAF bore on this Roush CAI. I don't have a...

    105mm MAF bore on this Roush CAI. I don't have a picture of the actual MAF sensor with me.
  5. Anyone have or know where I can find MAF Transfer Function for Roush CAI Coyote?

    Been looking online for MAF Transfer Function for Roush CAI for 5.0 Coyote with insert removed (tune required)? Thanks!
  6. Anyone know how to do "Pop Crackle" tune on 2015+ Mustang GT?

    On the early Coyote I see where people achieve this affect by manipulating Tip Out, Spark Decel Table. That table doesn't exist in 2015+ Coyote and I don't see anything similar. Any help is greatly...
  7. Replies
    5
    Views
    889

    Stock 2017 Raptor File

    Here is a 2017 Stock Raptor file if you want it.
  8. Replies
    5
    Views
    455

    I had the same issue and had to make sure my...

    I had the same issue and had to make sure my laptop was connected to the internet when I did the read before it downloaded the TCM.
  9. Replies
    15
    Views
    1,898

    Here you go....

    Sorry for the delay, haven't been on here in a bit. Here is the stock tune for the 17 and also a 19 3.5
  10. Replies
    5
    Views
    455

    Stock 2019 F-150 3.5 file here

    attached stock file for 3.5 w/10R80
  11. Turbo Speed for each EcoBoost engine needed

    I'm curious if anyone has a list of max turbo speeds for max efficiency for each Eco engine. I've been trying to keep the turbos on the 3.5 to about 225K. If you go above that they seem not do as...
  12. Replies
    15
    Views
    1,898

    Here is a tune for a 2017 3.5 Truck

    It is a pretty aggressive tune. Turbo speed is high up top and needs to be slowed down a bit with WG settings. Truck hauls ass though! Put down 373HP/517TQ.
  13. Replies
    4
    Views
    319

    I?d like that 2.7 file please!

    I?d like that 2.7 file please!
  14. Thread: ford raptor

    by Volstang
    Replies
    2
    Views
    237

    yes, you can tune a 2018 Raptor with MPVI2. You...

    yes, you can tune a 2018 Raptor with MPVI2. You will want to make sure you know what you're doing! Best of luck.
  15. You may want to try increasing IPC TQ limits in...

    You may want to try increasing IPC TQ limits in Torque Model->Monitoring the Torque Maximum table and MAP Maximum and see if that might help.
  16. Figured out that you have to keep Torque Module...

    Figured out that you have to keep Torque Module set to Enabled in Torque Management-General
  17. Reach out to Tony Gonyon at Tuners Inc in...

    Reach out to Tony Gonyon at Tuners Inc in Jacksonville, FL. He has tuned them and probably has a stock file.
  18. Idle issues after tuning 2016 3.7 Cyclone

    Did a basic tune to an otherwise stock 2016 3.7 Auto. Did TQ Mgmt stuff and added some Spark. Idle surges between 560-850ish. Car idled perfectly with stock tune. Played with Spark in MP0, changed...
  19. Replies
    1
    Views
    175

    Check the tune repository. I have a stock file...

    Check the tune repository. I have a stock file for a 2015 but I don't think it is exactly the same. From HP Tuners home page login to your account and go to Tune Repository and search for 2015 F150....
  20. Replies
    12
    Views
    1,153

    I have not tuned a Focus ST or 2.0 but have tuned...

    I have not tuned a Focus ST or 2.0 but have tuned a 3.5 Eco truck and a 2.3 Mustang. I'm certainly no expert and still learning too. With that being said, you want to log anything that is a 'Source'....
  21. Replies
    2
    Views
    957

    There is some info posted in this Transmission...

    There is some info posted in this Transmission forum that may help you with the info you are looking for. A poster who goes by 'Murfie' is pretty good with the 6R80 and has posted some info that may...
  22. Question regarding Fuel Base vs RPM vs TPS Table for 2015 5.0

    My Tuning School docs show a table (50151) that is under Engine>Fuel>Open & Closed Loop under the heading Base Fuel and the table is listed as Fuel Base but on my car under Open & Closed Loop I don't...
  23. Anybody care to share Channels they are using for 2017+ 3.5 Ecoboost?

    I know I'm not capturing everything I need. Particularly wastegate info.
  24. Replies
    17
    Views
    3,805

    I am trying to make adjustments for LU47...

    I am trying to make adjustments for LU47 injectors for a 2015 Mustang GT and I don't know how you determine what the fuel pressure is supposed to drop to if it was 55psi with stock injectors. I'm a...
  25. Sticky: Anyone familiar with tuning 2015-16 F-150 3.5...

    Anyone familiar with tuning 2015-16 F-150 3.5 Ecoboost also tune 2017+ and know the differences in the software as it relates to knowing what to change when modifying torque management, fuel, and...
Results 1 to 25 of 25