just shut the knock sensors off and not worry about it
Type: Posts; User: TT Sleazy
just shut the knock sensors off and not worry about it
i personally like to shut off the maf and just run off the VE, no calculations, just does what you tell it to. need to post mods and the tune file
how does it run now? main issues? and need to post a log with it
how do you get it to read the afr error while its in PE or in my case boost? I a have an afr error chart that reads my commanded and my wideband and it stops reading when it goes into PE
awesome. can I leave my wideband in gas scale and it read fine on e85? only cause I'm use to that rather than lambda
okay cool. ill dial in the tune on pump gas with the new injectors and then ill switch to e85 and see what happens
I have a SBE ls1, 78/75 turbo, conservative boost and timing. 48lb injectors and a walbro 450. I'm about to change Injectors to 100lbs, and I wanna run e85 with the new injectors. is it as easy as...
90059
does this look better?
thanks for the help
it was copied from one of the tunes, only because I didn't know where to start. The PE/BE seemed funky to me too, but then again I barely know what I'm doing. Can I use my timing table from my cam...
Need someone to see if my tune looks good to start making boost and start tuning with the turbo on it, and if timing is safe. just a look over, any help is appreciated. thanks 90018
Anyone?
Yes
SBE ls1, BTR stg3, 48lb injectors was just put in, been trying to dial the fuel in using an AFR error graph, cell hits on 25, logged 3 logs and pasted into the main VE by percent 1st time then...
So I need to get my hp tuners to read off my wideband, and create this graph? And then enable open loop? and log then paste the data in?
Also will wiring wideband up with the EGR work for the...
It is SD tuned, previous tuner shut the MAF off due to it having cheap junk injectors.
The car already has a wideband in it, not sure how to hook it up to HP tuners as I have the newer model HP...
The car was tuned by someone else before on junk injectors and the AFRs was good, now I put 48lb injectors and inputed the new data, and now its a little rich in PE and decel, and lean at part...