Search:

Question. I redid the wizard and it changed the values. But one thing I noticed is...it did not
change the pulses per mile for the ABS. Should I change those as well? I guess just do it
manually....

HI Blind Squirrel,

First of all thank you for replying. Sorry I took long to respond. During the week work is crazy and I had to build a Programming harness since I had pulled all the wiring out...

Good morning fellas,
I recently shoehorned an LS into my 04 Colorado. Everything went well. I used the P59 genIII ECM that came with the engine and the trainny. I've rewired most of the sensors and...

I figured it out.
thx for the help.

Good evening fellas,
I'm in the process of doing a swap on a Colorado. I've hooked everything up (mostly).
I turned on the PCM and downloaded the pcm file using my hptuner software. I found the...

Funny you guys should mention that. I did get a evap code a couple of months back. I replaced the canister. Could it be that the canister is a little skidish and not working correctly? AFter i got...

I have a summit truck cam in my 2008 ly5. Run 93 octane. I tuned it a while back and it's been running fine. I have everything turned on , so I'm not running
just the maf or VE table by itself. The...

Ok...so I popped in a mild Summit truck Cam into my truck(Gen 4 LY5 E38). I tuned the VE and Maf and I run the truck with everything turned on. Truck runs fine except for this one issue. I can crank...

thank you for the help.

Here is a tune from Sat. Getting there , just need to fix a couple of spots. I've tried to keep it simple and not trying to tweak a bunch of stuff - trying to play it safe.
You're also seeing...

Good afternoon fellas,

I've gotten the VE table more or less around stoich. I've done long boring drives feathering the pedal hitting as many cells as I've been able to. I've been doing slow...

I've been hesitant to do that being that the sensor was new and that I read up that the sensor should not be turned on without the truck running , due to the heat cycle it does and how high it goes....

i'm trying to tune my VVE table on my gen 4 ly5 2008 sierra. I've tried X by % half. Small increments in zone by zone only, smoothing , etc...etc..., but I'm starting to get a little frustrated. My...

This is what I was looking for.
:worship:

Edit: Brah!!!! I can't thank you enough for that tip. You just cut down my tuning to a third of time of what I thought I was going to have to do.

I...

There is a little thing called "the honey do" list that tends to get in my way and I work long hours during the week , so my time is limited most weekdays. The truck has a new summit cam 8718, so the...

I'm presently working on my VVE table on my truck. This is the first time I do this. From videos and reading ....the VE does take a while , possibly a couple of weeks to tweak it just right. My...

Yeah...i kept on searching and found another vid. That ve file needs some tweaks. Thank you for the critique and pointing me in the right direction.

Hi guys,
Ok, I receently swapped out the cam, lifters and deleted my DOD. It's a mild cam sum-8718, so the truck runs without having to do a tune, but I bumped up the maf and ve tables 2.5 percent...

Question. I"m using a similar FTDI FT232RL from DSD tech. I've used the terminal app shown above and I can send letters ,words ,whatever to the chip and with the jumper that is supplied for the input...

Hi fellas,

I just completed my cam swap on my 08 sierra with a 5.3. It has spectre cold intake and banks exhaust. I installed a summit 8718 cam for torque and just to wake the engine up a bit....