My car - 2017 ZL1 M6 - has been idling high since I let her out of the garage this spring. Put her on the dyno and was told I have negative torque values at idle which probably is the cause of my...
Type: Posts; User: Martinle
My car - 2017 ZL1 M6 - has been idling high since I let her out of the garage this spring. Put her on the dyno and was told I have negative torque values at idle which probably is the cause of my...
Hey, I know you:hi:. You are the one I referred to in the Gen 6 forum.
Am I correct in assuming HP Tuners have these addressed since they can be logged? If so, is there a way to get these from within HP Tuners? If not, any suggestions?
Thank you.
Thank you for your time, I very much appreciate it. I am going to install a DSX aux pump and call it good for the mean time.
I lowered the JMS to 17.37 and this is the log123058. What do you think. Again, it was pretty cool this morning, 70 degrees.
Hey Joshinator99,
I follow you on the Camaro forum. My power goals are met for the long run. If I ever find the money tree, who know what might happen? I am thinking that the DSX aux pump would...
Oh, I am running a 15% (9.34) lower and a 90mm upper.
Thank you for your time. I will turn down the voltage and check how much is getting to the pump. The e41, e50 and the 7000noJMS were done in second gear (m/t).
So, my take on your thoughts is...
123003123004123005
The log named e50 is the log I sent to JRE after final tune. The e41 was the next pull I did after they suggested that I only run e40. The 7000noJMS is self explanatory. I have...
When I get home, I will send you the logs. Can I send them through this site or do I have to email them? Thank you very much for your time and knowledge.
The JMS is outputting 17.5 volts at WOT. I am reasonable certain it is installed and setup properly. But here is the weird thing: I made multiple low to midrange pulls without issue to gather info...
Hey guys, I have a 2017 ZL1 Camaro with a 2650 Maggie and cam and all the other stuff. My question is whether or not I have to tune the FSCM to allow the 17.5 volts from the JMS to get to the low...
Thank you.
Hey Guys, I have a 2017 ZL1 Camaro. I have to drain the fuel tank. When I go into the fuel system and enable the fuel pump (MPVI2), it only runs for three seconds. I cannot find a way to disable the...