Search:

Type: Posts; User: tjd1991

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds; generated 54 minute(s) ago.

  1. i was able to mess with dtc's and make a tune...

    i was able to mess with dtc's and make a tune just to get through inspection. now i know i can do that im going to unplug them again. i will check to see if there is a difference. i have noticed it...
  2. Will this work on a gen v using e92 ecms? I ask...

    Will this work on a gen v using e92 ecms? I ask because I assume it will not but maybe with slightly different math? Or no because of the vve and not a true ve?
  3. I had to re install my rear o2s and zip tie them...

    I had to re install my rear o2s and zip tie them up to the frame. Drove to work and boom all permanent codes gone. I have all my rear o2 dtc’s set to no error reported with the ses enable still...
  4. Replies
    6
    Views
    5,018

    Str8dum 1, I just downloaded the latest beta it’s...

    Str8dum 1, I just downloaded the latest beta it’s still not there. Do you know if it’s something I have to contact hpt about or is there a sticky on how to add to an os? I have only read posts about...
  5. Replies
    6
    Views
    5,018

    Was this post in reference to an 8l90 with a t87...

    Was this post in reference to an 8l90 with a t87 tcm? I have tried both beta and standard editor and I am always in advanced view. I do not have the table above and I am wondering why
  6. Replies
    49
    Views
    22,238

    These engines dont want much over 20 degrees. I...

    These engines dont want much over 20 degrees. I know of some tuners who dont even add timing. Gm didnt leave a ton of power on the table on the Gen V's.
  7. Replies
    10
    Views
    3,442

    that is assuming you have raised your rev limiter...

    that is assuming you have raised your rev limiter correctly
  8. Replies
    10
    Views
    3,442

    zero the accel threshold rpm limit table. there...

    zero the accel threshold rpm limit table. there is also a setting to "use predicted torque" that is enabled from the factory and i believe that is what your issue is. its not shift points.
  9. probably going to run in 4th gear and somewhere...

    probably going to run in 4th gear and somewhere around 370
  10. Replies
    4
    Views
    1,184

    have you checked the repository?

    have you checked the repository?
  11. Replies
    14
    Views
    4,134

    you shouldnt be knocking on the stock spark map...

    you shouldnt be knocking on the stock spark map even on 91 in all reality. have you checked to make sure nothing is loose or rubbing? before changing anything with the injection timing, because i...
  12. Replies
    14
    Views
    4,134

    knock sensors can be sensitive to catless long...

    knock sensors can be sensitive to catless long tubes. i would recommend running 93 octane as well. do a search for injection timing and knock as well.
  13. post the tune so it can be reviewed

    post the tune so it can be reviewed
  14. Replies
    2
    Views
    1,176

    i have an 8 speed but i have had luck with...

    i have an 8 speed but i have had luck with lowering the shift mph and also under torque manangement there is a torque reduction table for downshift decelerating. i have made changes to that as well...
  15. Replies
    11
    Views
    3,162

    i have an N/A truck currently tuning the vve. i...

    i have an N/A truck currently tuning the vve. i found out cruise control wouldnt work while the maf is failed in the first 5 mins. but i didnt notice till a few days ago my throttle is being limited...
  16. Have you made any changes to the idle torque...

    Have you made any changes to the idle torque figures? If the low rpms aren’t an issue until your predicted torque source goes to idle then that may be why. It might run well at idle rpms in gear when...
  17. Replies
    18
    Views
    4,494

    Hondaeater my truck comes wired for a flex fuel...

    Hondaeater my truck comes wired for a flex fuel sensor you just have to install it and update the tune.
  18. Replies
    18
    Views
    4,494

    The intake air temp sensor on my truck is...

    The intake air temp sensor on my truck is internal to the maf. Won’t unplugging it just make it even harder to tune not having the iat temps reading?
  19. Replies
    18
    Views
    4,494

    Well if I had mechanical problems why would going...

    Well if I had mechanical problems why would going back to the maf only tune resolve the issue? The idle cells of the vve table were off, past that I have only been around +-5%. Once I got past the...
  20. Replies
    18
    Views
    4,494

    SOI changes help with knock and can also result...

    SOI changes help with knock and can also result in a power increase because of the increased efficiency. A lot of reading to do on that but I recommend it.
  21. Replies
    18
    Views
    4,494

    I am logging maf status and it is showing failed....

    I am logging maf status and it is showing failed. It’s a 6.2 truck so maybe that explains the throttle body numbers that you see? I haven’t made any changes to them.
  22. Replies
    18
    Views
    4,494

    yes. i drove it today and got a log in. i am...

    yes. i drove it today and got a log in. i am unable to get the p0103 ses on but the p0102 is giving the ses light. maf hz is still reading in the scanner but i can tell that the truck isnt using the...
  23. Replies
    18
    Views
    4,494

    Tried it again and just had to keep my foot on...

    Tried it again and just had to keep my foot on the throttle to stabilize it. So far I have had to increase the vve table by 30% to get it to idle. Idle torque is also increasing so that is a good...
  24. Replies
    18
    Views
    4,494

    9887898878

    9887898878
  25. Replies
    18
    Views
    4,494

    I have p0101-0103 set to mil on first error. Only...

    I have p0101-0103 set to mil on first error. Only one generating an ses is p0103. Do I need to see the ses for all 3? I will the the dynamic airflow back to original settings again. It didn’t make a...
Results 1 to 25 of 72
Page 1 of 3 1 2 3