Search:

here is a scan of a cold start, letting it idle to closed loop, then driving it until it stall when coming to a stop.

no i have not. can you explain the process to me? does this apply to vettes? thanks.

i just finished installing my fast 92/ls2 tb combo on and am having some issues. it starts and idles fine but when you drive it stalls when you engauge the clutch and come to a stop. it ran perfect...

i only have the wb output running to my eio without the ground.

mine did it yesterday for about a minute on startup. are you guys just using the one 5mv wire to the EIO without the ground?

i was at the track las night and when i shifted into second the car hesitated a bit, kind of like it pulled timing. i lanched of my 2 step at 6000 and it hooked perfectly and left hard. this is on...

thanks guys. i am going to double chech the wiring and in not i am going with the PLX m300.

it goes solid for a while then after driving around for a while it starts to blink.

what should your LED do when it is done warming up? mine stays on but then it starts blinking. is this right? i am getting so frustrated with it i am getting ready to pull it off and get another...

thanks guys it worked. now i am having a problem with my LC-1, it is givine me a heater error and cutting on and off. any ideas?

after i do this then i will be able to use this hitogram to tune my maf?

after i dialed in my Ltrims i set my MAF frequency back to 13500. after that my Ltrims start to read way postive again. i am trying to dial in the maf using this histogram but it is telling me:
...

so basically all we have to do is cut and paste are L & S trims into the spreadsheet and then paste the fulres into are VE table? is this for SD tuning?

this is a new laptop and has only seen 2.0. my old laptop had 1.6,1.7, and 2.0. this has happened on both laptops. all the files i am trying to open were scanned with 2.0.

when i do that it says "unable to parse log." what else can it be?

Every time I try to open data I have saved it comes up as a Microsoft Outlook file. I have tried the "open with" scanner method but it still does not work. I have installed the software on both my...