Yep, just giving a thumbs up to DGS... My MPIV2 had the same error "Unable to detect the vehicles diagnostic protocol". After a resynch all is good.
Type: Posts; User: chaas
Yep, just giving a thumbs up to DGS... My MPIV2 had the same error "Unable to detect the vehicles diagnostic protocol". After a resynch all is good.
OK, so I see the teasers that 3.1 is coming soon... how soon?
I haven't had much luck getting these things addressed in 3.0 - can they please be addressed in 3.1?
(1) DOD active bits! ...
Not sure if this is what you are seeing, but a possibility is that the chart is trying to plot a "sensor" as opposed to a "channel". Plotting a "sensor" seems to cause the chart to bounce between...
Anyone at HPT know when we will get the DoD status flags in the scanner? It has been over a month since Keith posted the message above. If it helps, I'm attaching a screenshot of the bits as seen...
Keith, do you have an ETA for a scanner version that includes the DoD status bits?
3.0.37
Thanks schpenxel - that helps. :-)
Keith - is fixing the two inoperable broadcast speed PIDs something that will be investigated?
How does one plot a "channel" versus a "sensor"?
The gauge and chart show strange values and oscillations on some channels. Seems to be when using multiple channels that have similar units. I understand that it might be good to interpolate...
When can we expect to see the missing scanner status bits/flags?
Some bits (like Fan1) are there in 3.0, but others (like DoD active) are missing compared to 2.24. (2009 G8GT)
I really like the new interface, and can't wait to play with the broadcast channels!
Question: Could someone help me locate the "DOD active" flag (I forget the exact name) in the channels (for...
Not sure if this will help as my experience is with the LC-2 instead of LM2, and mine was in the stock NBO2 bung, but I had to configure the output(s) to get a decent signal. I used the "LM400...
Does anyone know how to see or calculate what the ECM is actually using for TPS?
TPS seems like a simple enough concept in the editor, and is used as an input parameter for lots of things like...
Downloading v2.24.1165 and re-installing the software cured the issue.
Hi,
Any ideas what to check? I have the pro scanner, can scan PIDs as well as EIO, but nothing shows in the DTC window (even when I have a check engine light on). Tried it with and without an...
Cool. Thank you very much Gmtech16450yz! I'm curious where that table comes from as well. The 18% minimum (really 3.x%?) seems reasonable for idle I guess. So this conversion makes sense for the...
So how does one correlate TPS as shown in the scanner to TPS as referenced in the editor? I have a 09 G8, and just getting started with the tools. Was a bit surprised that the two tools don't seem...