Search:

Type: Posts; User: mjsmith2

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,671

    Just happened to me as well. Licensed a new...

    Just happened to me as well. Licensed a new personal vehicle last week using the latest stable version. All was well until I downloaded the latest beta today and went to try it out. MPVI 2 firmware...
  2. Replies
    3
    Views
    1,617

    This just happened to me as well. Licensed a new...

    This just happened to me as well. Licensed a new personal vehicle last week using the latest stable version. All was well for a while. Downloaded the latest beta today and went out to try it. MPVI 2...
  3. Replies
    7
    Views
    3,034

    The two files in question are in the tune...

    The two files in question are in the tune repository.
  4. Replies
    0
    Views
    909

    Missing Manifold EGT PID

    I believe a manifold EGT sensor was added to the 6.7 in 2015. On my 2019 I can read this with an Edge monitor but it doesn't seem to show up in VCM Scanner. Anyone else notice this?
  5. Replies
    7
    Views
    3,034

    2017 vs 2018 6.7 Tuning

    Has anyone compared the stock file from a 2017 with the stock file from a 2018 (both in the tune repository)? The cruise area specifically is pretty different considering the trucks are mechanically...
  6. Replies
    2
    Views
    1,348

    MPVI2.01 HW Version 1.3.0 Firmware Version...

    MPVI2.01
    HW Version 1.3.0
    Firmware Version 2.0.74
    VCM Editor 4.0.2
  7. Same issue here. Waiting on support. Were you...

    Same issue here. Waiting on support. Were you able to resolve this?
  8. Replies
    2
    Views
    1,348

    E92 Write Entire Timeout

    I just ran into a write timeout error while writing the entire os to an E92 ECM. Any further attempts to flash the vehicle result in an unlicensed vehicle error. I'm guessing the vin/os version no...
  9. Replies
    42
    Views
    21,788

    80275 80276 80277 The screenshot is from...

    80275
    80276

    80277

    The screenshot is from another run where I tried increasing the driver demand and peak torque tables by 10% but that made no change to the timing issue and made the...
  10. Replies
    42
    Views
    21,788

    Are you referring to a different torque...

    Are you referring to a different torque management advance pid than the one I was logging? During both runs it stays at 0. I believe it is correct as it shows tons of timing being pulled on wot...
  11. Replies
    42
    Views
    21,788

    I believe I have run into the same issue today....

    I believe I have run into the same issue today. 2015 Silverado 5.3. I started leaning out the PE values from .77 to .85 lambda and with no other changes lost 10* at peak torque. No crazy knock...
Results 1 to 11 of 11