Figured it out, the o2 sensors are labeled incorrectly
Type: Posts; User: grandamle91
Figured it out, the o2 sensors are labeled incorrectly
Can someone please look at the tune and see why P1129 is setting after having it tuned. Doesn't set on the stock tune
Thank you
143691
No Longer Responding. I remember why I stopped coming to this forum.
138001
138002
138003
Then stop replying, I already said I figured it out. It didn't like the stock timing at 20. Doesn't hunt with it set at 13
Don't know how any stocker it can get, but ok
137989
It's as stock as it can go
guess im going back to the lc9 tb. idle fine on that
I thought I switched it back to stock. Got that changed back, no difference. Only way I got it to idle smoothly was dropping the idle spark down to 13, but still randomly start to struggle to find a...
I'll try it again, it was worse with the stock lc9 pids, the under over weren't changed
they are the same
137936
I have a gold blade tb 19420707 on my 2010 Suburban 5.3 and have a issues with the idle randomly bouncing around. It's usually just 100 rpms or so enough to hear it. I've change the Idle ETC Area...
Does anyone know if there is a option to adjust for tip in on the P04 PCM's. I got a couple 3.4s from idle or sitting at a light when you go to take off it will stumble (rpms drop) then go.
I'm using a 9405 os, that's flex enabled and 6.0
mines a 03 os, I found a way using some custom software
Here's a log, this time timing didn't drop like before. ignore the misfires I forgot I had higher the detection and forgot to change it back
103392 I used this one
If you're referring to this excel >> http://files.hptuners.com/support/Excel/injectorscalels2.xls << it doesn't exist
Gen4 map tune was changed to 128.20 kPa
Wire
I'll post up a log...
Can someone look my tune over and see if I missed something
Its a LQ4 with 243's TBSS 2010 flex injectors. Timing goes -20 at start up and after it goes into CL the trims are everywhere
103377
That's what I thought, so as long as the pcm has the drivers I could just change that and populate the necessary tables it should work?
Is there a way to tell if a OS is Drive By Cable or Wire?
I've been searching like crazy and can not find a 12593058 os with a lq4 and 4l80e. everyone I find is for a 4.8 or 5.3. Need it for a flex fuel segment swap
For the ac the only thing I can think of doing since the vans use 2 connectors instead of one like the 3.8 cars , is to swap the van lines to the 3.8 cars, you will lose rear air unless you solder...
Yea, trans shifts and acts fine, van is dailyed 200 miles, vats was disabled, bcm in these vans are very basic and really don't care about the pcm, as far as I can tell from the service manual the...
I used a pcm from a 04 Impala SS, and worked fine
It's just one pcm i'm tuning, but can I use any p04 pcm or does it have to be a impala\monte pcm since I will be doing a full write