I'm trying to read a 2018 ZL1 and it gives an error every time. I've been thru tech support with no real answer to the Issue. Yes I'm connected to the internet. I was told it might be a firewall...
Type: Posts; User: coulterz28
I'm trying to read a 2018 ZL1 and it gives an error every time. I've been thru tech support with no real answer to the Issue. Yes I'm connected to the internet. I was told it might be a firewall...
Someone put a base tune in this truck. Was brought to me to tune. Program read fine but when going to reflash it unlocker failed. Now the truck is inoperative. Will not crank. I can read codes...
We have a 2016 Camaro we did a D1SC Procharger and btr cam in. Looking for a reliable tuner to dial it in. I've not tried to learn the DI stuff yet and don't plan to learn on this one. LOL
...
We pulled a program on an 07 GT and licensed it. Turns out it was previously tuned with sct. So the file was useless. It would let me reflash the car but would not start. Sent the car to the...
Do I need something special to communicate with the new camaro? I have 2.2 but it will not communicate.
Got it, we'll trying it tonight.
Need the segment swap done on this file for a 4L80 trans. Got everthing in but we need this to make it work I guess.
Car is a 69 camaro with an ls7 swap in it. The engine is bone stock except for the swap headers. It idles rough and peaks power at about 5400 which is low compared to a normal z06. It is showing...
Here's the one log file I have from it.
I had an 06 solstice on the dyno today. The car had just under 9000 miles on it and it seems like it had some issues. The dyno graph was pretty choppy and it wanted to knock retard. After getting...
I'm tuning on a procharged application with 8psi of boost. I have the commanded PE set to 12.0. On the dyno it is adding fuel via LTFT @ WOT after a couple of pulls. The actual A/F ratio is deep...
I've starting having some strange run issues and now I finally get it to set some codes. The check engine light never comes on but this comes up.
...
Don't you have to apply the RTT to do real time tuning? That's what I'm trying to do.
I've downloaded the update for my software but it says 1 Bar Maf Enhanced RTT unlicensed. I have 2 bar software so the 1 and 2 bar show not applied. What am I missing?
The open loop commanded air/fuel was different. Plus the LTFT's were adding fuel so when I reset them it was showing much leaner. Makes for some clean plugs though. : )
In closed loop it shows 14.6
I just got my car running on the new cam and the LTFT are anywhere from 12 to 25 red for idle. Here's where it doesn't make sense to me though. I have an FJO wideband in the car (not hooked to...