Search:

installed injectors runs fine but can tell its rich from the rpm decel, as expected, would changing to the larger injector parameters richen or lean out the system? or install larger parameters and...

originally bought a set of deatschwerks 38# injectors but 2 went bad and no longer available, so they sent me 8 new balanced 44# injectors, what all do i need to change to get them to work with what...

just changed some of the dtcs watched and reloaded and now cylinder #2 and #5 act as if they are dead, turn off injectors but still runs the same, is it possible the tune was corrupted some how? did...

e38 eng computer in a 1955 chevy truck vin comes up as 2001 truck

truck has thrown P0011 again, thought it was a fluke code last time it was thrown. The motor is brand new from Gm and is not a VVT motor, and has never been opened. Is this a flash issue or a base...

Thank's Keith! updating worked!

new to this other than looking at posts I think i did it correctly

where are the pids? is that whats in the channels menu? but if if the scanner is reading and the scanner is displaying the correct value in the KPA gauge then the wiring should be fine correct also...

tried to load post my log file was wondering if i did it correctly?

is there any way to watch the MAP sensor voltage that the computer is seeing other than driving around with the fluke under the hood, or change KPA to volts on the VCM scanner, keep getting P0108...

updated this mouring willl let you know if that fixes it

says VCM editor 3.4.89

scanner just started to stop updating smoothly, stops for awhile and start back up again, just started doing this only have used usb cable 10-15 time now , not a tuner, will this affect trying to...

have a brand new 5.3L crate engine that is bone stock except cold air, continue to have p0108 that keeps coming back, voltage is
4.8v at 0 inhg and 110 kpa
3.661v at 5 inhg and 90 kpa
2.760 at 10...