Hello,
I'm new to HP tuners and would like to know how to resize the columns in VCM Editor especially in the window with the engine dtc's I can figure out which code I'm looking at but it would...
Type: Posts; User: Edster
Hello,
I'm new to HP tuners and would like to know how to resize the columns in VCM Editor especially in the window with the engine dtc's I can figure out which code I'm looking at but it would...
Hello, I would like to know if a 2010 Mercedes C300 is supported by HPTuners VCM Suite VCM Editor? I was able to connect with the VCM Scanner and save a log. But I didn't see the car listed on the...
I drove the car before disabling anything to do with the rear o2 sensors. The only codes that popped up were p0420 and p0430 catalist efficiency codes. I turned them off in the tune and no more...
I set the thermostat temp to 174 where do I set the fans to come on sooner? Would that be the desired ECT table? I went from 194 to 174 so is reducing those values by 20* a good place to start?
...
Ok, theres a min temp currently 63* below that cat warmup is disabled, and a max temp currently 109* above that cat warmup is disabled. Should I set the max temp to 63 or 64 to disable cat warmup...
Hello, I'm new to HPTuners and the fourm. I have a 2016 Z06 A8. I mainly use the car for HPDE at the Autobahn country club. The car is stock besides an Akrapovic exhaust with a catless xpipe. It...