I feared that might be the case. Thanks for the info.
Type: Posts; User: Ricks82
I feared that might be the case. Thanks for the info.
I'm trying to help out with a 2004 Z06. The car had already been modified with cam, heads, long tubeheaders, etc. The car had been tuned and driving on the street. The owner has now pretty well...
My bad. It's a Durango Citadel. I had access to the car yesterday for a little bit so I have the tune file and one datalog. There are more mods to the car than I originally thought. It does have long...
Since this is a 2012 5.7 will it have dodges Neural Network? With social distancing in full swing where I live, I have not touched the car yet.
I feel that I preface this with the fact that I am not new to HP Tuners, But I know nothing about tuning Dodge vehicles.
I have tuned serval LS vehicles, but after considerable reading I'll say most...
Not sure where to put this, but I decided to try to upload the factory tune file for my 2020 Sierra 6.2L and post it in the repository, But so far I cannot read the tune file. Is a ECM mod required...
Sooo, Actually I had dropped the first four cells to 6 lb/h (not 6 g/s). While this did totally eliminate P0335, the car started like crap but did prove my theory about where the code was coming...
I've read that the P0335 diagnostic compares the crank sensor to the cam sensor and MAF in a static (not running) condition. The logs were showing up to 1450hz or 65g/sec before I started the car....
I am working on a LS2 with the Mods listed below. It was tuned on a dyno a few hours from me. It has several issues including cold start, open loop idle surging, Idle surging when moving with clutch...
Thanks for the input guys. I did wonder about the PE rpm, but I only had a small amount of time to drop in my first changes and then log some data. Being new at this I didn't want to change too many...
Hi guys, I'm helping a friend with his 04 Silverado 8.1L (with Allison). Just reducing Torque Management and trying to get the truck into PE. So far I'm happy with where we're at with the torque...
Bump
I recently purchased a 2010 corvette with Edelbrock Eforce SC already installed. This was a southern California car but I live in Illinois. It didn't take me long to figure out that the IAT sensor...
I think last fall the temps may have been colder, not so sure about this spring. Anyway I'm ready to move forward. I've drove the car to work twice so far and its been running great. I think I've...
Update,
I went for a little drive with both IAT tables loaded with the Fahrenheit scale. The car started and ran great. I did find out from another eforce equiped corvette owner that their tune had...
I Purchased a 2010 Corvette with eforce sc already installed. This is an older eforce with the ford tmap sensor. Last fall I a local tuner load the correct IAT tables directly from the Edelbrock...